Draper 70276 Original-Bedienungsanleitung - Seite 9

Blättern Sie online oder laden Sie pdf Original-Bedienungsanleitung für Elektrowerkzeug Draper 70276 herunter. Draper 70276 20 Seiten.

5.2 ADDITIONAL SAFETY INSTRUCTIONS FOR IMPACT WRENCH

Warning!

1) Safety instructions for all operations

a) Wear ear protectors. Exposure to noise can cause hearing loss.

b) Brace the tool properly before use. This tool produces a high output torque and without

properly bracing the tool during operation, loss of control may occur resulting in personal

injury.

c) Hold the power tool by insulated gripping surfaces, when performing an operation

where the fasteners may contact hidden wiring or its own cord. Fasteners contacting a

"live" wire may make exposed metal parts of the power tool "live" and could give the

operator an electric shock.

5.3 SAFETY INSTRUCTIONS FOR MAINS POWERED CHARGERS &

BATTERY PACKS

Chargers

–

The charger is for indoor use only.

–

Prior to plugging the charger in to the supply, check that the plug, cable and charger casing

are in good condition. If any are damaged, have the defective part(s) replaced immediately by

a suitably qualified person.

–

Only use a correctly rated mains outlet to provide power, do not plug into site generators, attach

to engine generators or D.C. sources. Do not use a mains socket outlet that is not switched.

–

Use the correct Draper charger in conjunction with it's corresponding battery pack (consult the

Draper website for more information or to find your local stockist).

–

Do not charge any other batteries with Draper chargers. Any other application is considered

misuse.

–

Do not attempt to charge battery packs that are too hot (over 30°C) or too cold (under 5°C),

if these conditions apply set the battery pack aside to "normalise" before proceeding with the

charging operation.

–

Set up the charger and cable in a safe place where it won't be knocked, tripped over, stepped

on, etc. and where it is well ventilated. Make sure the ventilation slots in the charger case are

not obstructed.

–

Inspect the battery pack for damage, if it is undamaged, plug it into the charger, ensuring the

correct orientation.

–

Switch the charger on and check that the correct indicators illuminate, allow the battery pack

to charge (see the specific instructions for your charger). Once charging is complete, switch

the charger off, disconnect from power supply, remove the battery pack and store.

– 9 –