Draper 72623-PTW Anleitung Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Elektrowerkzeug Draper 72623-PTW herunter. Draper 72623-PTW 16 Seiten. Torque wrenches

INTRODUCTION

This torque wrench is used to apply a specific torque to a fastener such as a nut or bolt.

Stock no. ....................................72673 ................................. 72714 .....................................83317

Part no. ....................................... PTW.................................... PTW ........................................ PTW

Torque range ........................... 5-35Nm............................ 25-135Nm...........................50-225Nm

..................................................4-25lb/ft ...........................20-100lb/ft .........................40-160lb/ft

Accuracy .................................... +/- 4%................................ +/- 4%....................................+/- 4%

Square drive size .................... 1/4"+3/8" .............................3/8"+1/2".......................................1/2"

Overall length approx ............. 340mm .............................. 565mm ................................ 625mm

Manufactured and tested in accordance with to ISO 6789 Standards.

Whilst every effort has been made to ensure that the accuracy of information given in this manual

is correct at time of going to print, the Draper Tools policy of continuous improvement determines

the right to change specification without notice.

This torque wrench is accurate to ± 4% of the set load and has been manufactured and tested in

accordance to ISO 6789.

Torque tools are classified as test devices. If a calibration routine is required, the calibration

interval shall be chosen on the basis of the factors of operation such as required accuracy,

frequency of use, typical load during operation as well as ambient conditions during operation and

storage conditions. The interval should be decided according to the user's procedures for the

control of test devices and by the requirements of the user.

If the user does not use a control procedure, a period of use of 12 months, or approximately 5000

cycles can be taken as a default value of the recalibration interval. For the first recalibration,

the period of validity starts with user's first operation of the torque tool.

In addition to these specifications, factory or legal regulations shall be observed.

The torque tool shall be recalibrated when it has been subjected to an overload greater than 125%

of maximum rated load and after repair, or after any improper handling which might influence any

errors in measurement.

4.3 HANDLING & STORAGE

Ensure you have a good stable position whilst using this product. Care should be exercised when

using this product due to rotating parts etc.

Store the product together with this manual in its protective case in a cool dry place with the torque

wrench set to its minimum setting.

This product should be cleaned, maintained and lubricated regularly to ensure it is operating at

peak performance.