Draper BS355A Anleitung Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Säge Draper BS355A herunter. Draper BS355A 20 Seiten. 360mm bandsaw

Seite drucken

MITRE GUIDE

Most cross cut work, especially with small

pieces of material are more easily controlled

with the aid of the mitre guide

is graduated to 45˚ for assistance in cutting

both left and right hand angles. Fig.13.

RIP FENCE

True straight line rip cutting is best done by

guiding the work against the rip fence

The fence can also be used for cutting off

exact widths. Fig.14.

WARNING: The supporting surface where the

band saw is mounted, should be examined

carefully after mounting to ensure that there is

no movement during use. If any tipping or

walking is noted, secure the workbench or

supporting surface before operating

bandsaw.

CIRCLE CUTTING ATTACHMENT

The circle cutting attachment

the arm of the upper guide block

Accurate circles can be cut out with a radius

of 50mm - 200mm

Make the first cut to the perimeter of the

circle freehand before setting the pivot pin

of the attachment into the work. The pivot

pin must be aligned exactly to the right of the

blade tips. If the pivot is too far back, the

blade will run outside the desired

circumference. If too far forward, the blade

will run inside.

USING YOUR BANDSAW AS A POWER BELT

SANDER

Remove the blade and fit a sanding belt

as explained in CHANGING BLADES

(page10).

However, make sure that the blade support

bearings and the blade guides, both upper

and lower, are well clear of the abrasive

sanding belt. Two sanding stops are available,

one straight and one slightly curved. Screw

the stop into the threaded hole in the

worktable near the table insert with the hex

screws provided with the sanding kit. Adjust

the stop so that the belt just rests against it.

OPERATION & USE

. The guide

mounts on

Fig.13.

Fig.14.

Fig.15

Fig.16.

- 11 -