Draper Dual Roller FlexShade NEXD Anweisungen für Installation und Betrieb - Seite 8
Blättern Sie online oder laden Sie pdf Anweisungen für Installation und Betrieb für Inneneinrichtung Draper Dual Roller FlexShade NEXD herunter. Draper Dual Roller FlexShade NEXD 10 Seiten. Heavy-duty, clutch-operated window shade
Seite drucken
Dual Roller FlexShade
Section 7 - Attaching Fascia
!
Ensure that fascia engages
with the metal portion
of the endcap.
Figure 8-A
A
B
Figure 8-B
SIDE
VIEW
Section 8 - Bead Chain Limits and Safety Device Installation
Attaching Stop Balls
1. Set upper and lower travel limits by installing stop balls to bead chain
P-Clip Cord Tension Device
Please Note: Draper
Bead Chain Clutch-Operated shades that do not comply with WMCA/ANSI Standard A100.1-2012
®
come with a P-Clip cord tension device pre-attached to bead chain
jamb, or sill so that bead chain is held taut enough that children cannot pull it away from wall or fit their head into loop.
Spring-Loaded Cord Tension Device
If Draper Clutch FlexShade complies with WMCA/ANSI Standard A100.1-2018, a Spring-Loaded Cord Tension Device
comes installed on bead chain
(Fig. 9-C)
are included. Device is designed so that children cannot pull bead chain away from wall or fit their head into loop.
screws)
. For more information, visit www.draperinc.com/WindowShades/WCMAcompliance.asp.
(See safety note on page 2)
1. Install cord tension device to wall, jamb, or sill.
2. Pull tensioner down so that bead chain is held taut and use mounting hardware to keep it taut.
Please Note: Bead chain should be taut enough to move smoothly through device. However, overtightening screws will
damage Spring-Loaded Tension Device.
NEXD
®
N E
e r
I d l
!
X D
a p
N E
d c
Fascia is not
E n
fully seated until
it clicks into place
on both ends.
STEP 1
. An approved permanent warning label and approved mechanical fasteners
A
X D
C l u
E n d
t c h
c a p
B
Insert
fascia.
Clicks into place.
(crimp closed using pliers) (Fig. 9-A)
. This device must be attached to wall,
(Fig. 9-B)
A.
Position fascia flush to edge of bracket
and/or butted to endcap cover.
B.
Snap firmly into place.
Please Note: Fascia should be
installed top to bottom, with the
bottom edge clicking/snapping
into position.
STEP 2
Chain Limits
1. Attach
.
stop balls.
Figure 9-A
Chain Tension Device
(wood
Sill
Mount
page 8 of 10
P-Clip
P-Clip
2. Crimp
closed
with
pliers.
Figure 9-B
Jamb
Mount
Figure 9-C
Tensioner