Draper LightBloc ZIP 92 Anweisungen für Installation und Betrieb - Seite 3

Blättern Sie online oder laden Sie pdf Anweisungen für Installation und Betrieb für Inneneinrichtung Draper LightBloc ZIP 92 herunter. Draper LightBloc ZIP 92 12 Seiten.

Seite drucken
LightBloc ZIP™ 92 & ZIP 127

Section 1 - Site Preparation

Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
MOUNTING
1 "
BRACKET
(44 mm)
E N
D C
Figure 1
A P

Section 2 - Curved or Square Headbox Mounting

Section 2.1 - Wall Installation
1. Drill small starter holes
(if necessary)
2. Attach Mounting Brackets to the wall using #10 flat head screws installed flush with bracket.
Please Note: Be sure to use AT LEAST 2 of the top mounting holes
3. Ensure brackets are level.
4. Attach Headbox to brackets and
tighten Set Screws
.
(Fig. 3-A)
5. Mount the Side Channels
.
(Section 5)
Figure 3-A
Section 2.2 - Ceiling Installation
1. Attach Mounting Brackets
to ceiling using #10 flat head
screws installed flush with
bracket. USE ALL FOUR
(4)
mounting holes
.
(Fig. 3-B)
2. Attach Headbox to brackets
and tighten Set Screws
.
(Fig. 3-B)
3. Mount the Side Channels
.
(Section 5)
1. Ensure mounting surface is strong enough to hold unit.
2. Verify unit measurements, ensuring it will fit
in the desired location.
Caution: Hem Bar does not retract into
the Headbox. Provide at least 2 1/4"
clearance if mounting over a swinging
window or door.
3. Mounting Brackets MUST be installed with
a gap of 1 3/4"
between the Endcap
(44mm)
and the Mounting Bracket edge
Mark wall, jamb, or ceiling.
4. Determine which Headbox style is being
installed
.
(Fig. 2)
PLEASE NOTE: Refer to appropriate sections within this document
for different installation options:
SECTION 2: Mounting Unit with Brackets
SECTION 4: Mounting Unit Directly to Ceiling or Wall
SECTION 6: Installing Angled Headbox
in mounting surface.
(Fig. 3-A)
1
1
Figure 3-B
LightBloc ZIP
(57mm)
92 Square
Headbox
5"
(127mm)
.
(Fig. 1)
LightBloc ZIP 127
Square Headbox
(Curved or Square Headbox ONLY)

(Curved Headbox shown)

.
2
2
Figure 2
HEADBOX STYLES
3 "
3 "
(92mm)
3 "
(92mm)
5"
(127mm)
5"
(127mm)
LightBloc ZIP 127
Angled Headbox
3
3
4
page 3 of 12
(92mm)
LightBloc ZIP
92 Curved
Headbox
5"
(127mm)
5"
(127mm)
LightBloc ZIP 127
Curved Headbox
4
Tighten Set Screws
Tighten Set Screws