Bosch WLK24261BY Gebrauchsanweisung und Installationsanleitung - Seite 16

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung und Installationsanleitung für Waschmaschine Bosch WLK24261BY herunter. Bosch WLK24261BY 42 Seiten.

Seite drucken

Programme default settings

en
0
Programme default
settings
P r o g r a
m m e
The temperature, spin speed and
programme duration (Ready in time) for
all programmes are preset at the
factory.
These are displayed in the display panel
after selecting the programme.
You can change the default settings as
follows.

Temperature

Depending on the programme
progress, you can change the preset
washing temperature (in °C) before and
during the programme.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
The maximum temperature that can be
set depends on the programme which
has been selected.
Overview of programmes ~ Page 13

Spin speed

Depending on the programme
progress, you can change the spin
speed (in rpm; revolutions per minute)
before and during the programme.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
Setting – – – : Rinse hold = without final
spin, the laundry remains in the water
after the final rinse.
You can select "Rinse hold" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
Maximum spin speed depends on the
programme and model.
Overview of programmes ~ Page 13
16
t
d e f a u l

Ready in

The respective programme duration is
displayed by selecting the programme.
i n g s
s e t t
The programme duration is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings also change the
programme duration.
Before starting the programme, the
programme end (Ready in time) can be
pre-selected in increments of one hour
(h = hours) up to a maximum of 24
hours.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
The programme duration is
Note:
included in the selected Ready in time.
After the start, the preselected time e.g.
8h is displayed and the time counts
down to the start of the wash
programme. The programme duration is
then displayed, e.g. 2:30
(hours:minutes).
Changing the preselected time:
You can change the preselected time
before the start of the programme as
follows:
Select Start/Reload.
1.
Press the Ready in button
2.
repeatedly until the required number
of hours is displayed.
Press the Start/Reload button.
3.
Adding laundry while the pre-selected
time continues running:
Select Start/Reload.
1.
The symbols YES and ¼ light up in
2.
the display panel. The washing
machine door can be opened and
laundry can be added.
Close the washing machine door.
3.
Press the Start/Reload button. The
4.
preselected time continues to run.