Drawmer M-Clock Plus DMS-5 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Medienkonverter Drawmer M-Clock Plus DMS-5 herunter. Drawmer M-Clock Plus DMS-5 10 Seiten. Aes grade 1 master clock and dual sample rate converter

Seite drucken

The Drawmer M-Clock Plus supplies ten word clock outputs,

as well as two simultaneous outputs of S/PDIF and AES/

EBU allowing you to synchronize your digital workstation, A/D

converter, digital mixer and a host of other digital audio

equipment through one stable and very accurate unit.

Certain equipment in the studio may not have word clock

inputs which has in the past caused synchronisation

problems, using the DMS-5 M-CLOCK Plus these digital audio

sources may be synched to the same ultra low jitter AES

Sample Rate Converter 1

SOURCE

WORD LENGTH

Sample Rate Converter 2

SOURCE

WORD LENGTH

DISPLAY

CONTROL DESCRIPTION

Three inputs are conveniently located on the front panel for easy access - SPDIF, TOSLINK and AES.

Toggle through the "Source" switch to select the desired input. A lock LED is provided - when lit a

strong signal is being recieved by that input source and the M-Clock Plus is "locked on". If the LED

is off the input source may be missing, weak or unstable - in this case the source of the signal

should be located and improved.

A switch provides either 16 or 24 Bit operation.

Toggle through the "Source" switch to select the

desired input on the S.R.C.2 outputs on the rear

panel. A lock LED is provided on the front - when lit

a strong signal is being recieved by that input

source and the M-Clock Plus is "locked on". If the

LED is off the input source may be missing, weak

or unstable - in this case the source of the signal

should be located and improved.

As above.

A Blue/White LCD display wth four switchable modes of operation: When reading from it's own

internal clock the M-Clock Plus will display a sample rate of 44.1kHz. , when reading from an

EXTernal source it displays either FREQ, ±PPM or ±% depending on the mode set.

The mode that is selected during power down is saved for the next session.

The display accuracy is 2ppm at all sample rates up to 192kHz, or 0.1Hz increments @

48KHz sample rate

grade 1 stability master clock generator as the equipment

using the word clock outputs from the DMS-5.

In addition, if any equipment in the studio suffers jitter at its

output these sample rate converters may be used to de-jitter

and re-clock the signals before further transmission.

The M-clock Plus provides a wide range of sample rates

from 44.1k upto 192k, all set using the front panel switching.

Each sample rate converter input is fed simultaneously to

AES/EBU, SPDIF and TOSLINK outputs solving any

connectivity problems and allowing signal distribution.

CHAPTER 2