Bosch 300 Series Gebrauchs- und Pflegeanleitung / Installationsanleitung - Seite 15

Blättern Sie online oder laden Sie pdf Gebrauchs- und Pflegeanleitung / Installationsanleitung für Backofen Bosch 300 Series herunter. Bosch 300 Series 40 Seiten. Built-in wall ovens
Auch für Bosch 300 Series: Gebrauchsanweisung Handbuch (40 seiten), Benutzerhandbuch (21 seiten), Installationshandbuch (6 seiten), Installationshandbuch (36 seiten), Installationshandbuch (32 seiten), Betriebsanleitung (50 seiten), Schnellstart- und Sicherheitshandbuch (7 seiten), Installationshandbuch (28 seiten), Schnellstart-Handbuch (7 seiten), Handbuch für Gebrauch und Pflege (32 seiten), Schnellstart- und Sicherheitshandbuch (7 seiten), Service-Handbuch (36 seiten), Schnellstart- und Sicherheitshandbuch (13 seiten)

Bosch 300 Series Gebrauchs- und Pflegeanleitung / Installationsanleitung
ALL ELECTRICAL CONNECTIONS AND CIRCUITS
WARNING
9
ELECTRIC SHOCK HAZARD
Do not pull on the power cord to unplug the
dryer.
Protect the power cord from physical damage
such as being twisted, kinked, pinched, or walked
on for example.
DO NOT use an extension cord or an adapter to
connect the dryer to the power supply.
Make sure:
The power cord fits into the outlet/receptacle.
The home's internal power supply circuit wire size is
sufficient and electrically grounded.
The outlet/receptacle used to power the dryer
must be connected to an individual 30 amp
Branch Circuit.
Do not cut, remove or bypass the grounding
prong on the power cord end.
Do not modify the plug provided with the
appliance; if it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
The power cord must only be replaced by a
qualified technician or licensed electrician to help
avoid a fire/electric shock hazard.
Replacement power cords can be purchased
through our Customer Service department.
Use only a UL listed 30 amp power cord.
Do not reuse old power cord.
Do not make a sharp bend or crimp wiring or
conductors at connections.
Use only a 4-wire/conductor power cord when
the appliance is installed in a mobile home,
recreational vehicle, in a new branch-circuit
installation or where the local codes do not
permit grounding through the neutral.
WARNING
9
ELECTRIC SHOCK HAZARD
To reduce the risk of electrical shock:
Only pull out the power cord by the plug end and
never by the cord, as this could damage it.
Never touch or hold the plug end or power cord
with wet hands.
Never unplug the plug end during operation.
WARNING
9
ELECTRIC SHOCK HAZARD
Improper connection of the equipment-grounding
conductor may result in electric shock. Have the
appliance checked by a qualified technician or
licensed electrician if you are in doubt as to whether
the dryer has been properly grounded.
GROUNDING INSTRUCTIONS
WARNING
9
ELECTRIC SHOCK HAZARD
This appliance must be electrically grounded. In the
event of malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a path
of least resistance for electric current.
This appliance is equipped with a cord that has an
equipment grounding conductor and a grounding
plug.
The plug must be plugged into an appropriate outlet
that is properly installed and grounded in
accordance with all local codes and ordinances.
If a ground fault circuit breaker is used, ensure it
has this symbol:
z
Only this symbol can assure compliance with all
current regulations.
SAVE THESE INSTRUCTIONS!
Connecting a 3-wire power supply cord
WARNING
9
ELECTRIC SHOCK HAZARD
To reduce risk of fire, electric shock, serious injury,
or death follow the installation instructions below
carefully or have work done by an qualified
electrician.
The power cord must meet the following requirements:
208-240 volt rated (minimum);
30 amps;
Type SRDT or DRT (UL 2158).
Unplug the current power cord being used from the
1.
outlet/receptacle.
To disconnect and/or reconnect a new power cord
2.
you must remove the top cover of the appliance as
shown below.
A. Remove the two T20 torx head screws.
B. Push the top cover toward the rear of the appliance
and lift up.
.
15