Bosch 800 Series Installationsanleitung Handbuch - Seite 6

Seite drucken

Bosch 800 Series Installationsanleitung Handbuch

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS

Cleaning Safety

WARNING

Be sure the entire appliance (including the grease filters

and light bulbs, if applicable) has cooled and grease has

solidified before attempting to clean any part of the

appliance.

Do not use steam cleaners to clean the appliance.

Safe use

WARNING

Do not repair, replace or remove any part of the

appliance unless specifically recommended in the

manuals. Improper installation, service or maintenance

can cause injury or property damage. Refer to this

manual for guidance. All other servicing should be done

by an authorized technician.

WARNING

RISK OF INJURY

Items placed on the appliance may fall down. Do not

place any objects on the appliance.

Proper Installation and Maintenance

Have the installer show you the location of the circuit

breaker or fuse. Mark it for easy reference.

This appliance must be properly installed and grounded

by a qualified technician. Connect only to properly

grounded outlet. Refer to Installation Instructions for

details.

This appliance is intended for normal family household

use only. It is not approved for outdoor use. See the

Statement of Limited Warranty. If you have any questions,

contact the manufacturer.

Do not store or use corrosive chemicals, vapors,

flammables or nonfood products in or near this

appliance. It is specifically designed for use when

heating or cooking food. The use of corrosive chemicals

in heating or cleaning will damage the appliance and

could result in injury.

Do not operate this appliance if it is not working properly,

or if it has been damaged. Contact an authorized

servicer.

Do not repair or replace any part of the appliance unless

specifically recommended in this manual. Refer all

servicing to a factory authorized service center.

CAUTION

Grease left on filters can remelt and move into the vent.

CAUTION

Turn power off at breaker before removing a damaged

bulb. Do not touch the bulbs immediately after use. The

bulbs will remain hot for several minutes.

WARNING

Make sure the appliance and lights are cool and power

to the appliance has been turned off before replacing the

light bulb(s). Failure to do so could result in electrical

shock or burns.The lenses (if equipped) must be in place

when using the appliance.The lenses (if equipped) serve

to protect the light bulb from breaking.The lenses (if

equipped) are made of glass. Handle carefully to avoid

breaking. Broken glass can cause an injury.

Hidden surfaces may have sharp edges. Use caution

when reaching behind or under appliance.

WARNING

When the hood is operated in exhaust-air mode

simultaneously with a different burner which also makes

use of the same chimney (such as gas, oil or coal-fired

heaters, continuous-flow heaters, hot-water boilers) care

must be taken to ensure that there is an adequate supply

of fresh air which will be needed by the burner for

combustion.

Safe operation is possible provided that the under

pressure in the room where the burner is installed does

not exceed 4 Pa (0.04 mbar).

This can be achieved if combustion air can flow through

non-lockable openings, e.g. in doors, windows and via

the air-intake/exhaust-air wall box or by other technical

measures, such as reciprocal interlocking, etc.

WARNING

Avoid carbon monoxide poisoning – Provide adequate

air intake so combustion gases are not drawn back into

the room.

An air-intake/exhaust-air wall box by itself is no

guarantee that the limiting value will not be exceeded.

Note: When assessing the overall requirement, the

combined ventilation system for the entire household

must be taken into consideration. This rule does not

apply to the use of cooking appliances, such as

cooktops and ovens.