Alemlube 200A Benutzerhandbuch

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Werkzeuge Alemlube 200A herunter. Alemlube 200A 2 Seiten. Lever action grease gun

Seite drucken

Description

The 200A manufactured in Germany, is a lever action 400g grease gun capable of generating up to 12,000psi.

It comes standard with a 16.5cm rigid extension & 4 jaw coupler for lubricating points.

It has 500g bulk grease capacity & comes with 4 year warranty.

Specifications

Uses

Pressure Capabilities

Delivery

Operating Instructions

There are two ways to fill the gun with grease:

A: 400g Grease Cartridge:

Unscrew the grease barrel from the gun and insert the 400g grease

cartridge by holding the barrel assembly and pulling the rod back.

Remove cap from the grease cartridge, insert the cartridge into the barrel

and then rescrew the barrel assembly back onto the gun so that the cartridge

sits well against the follower cup. Once in position, press the clamp down

& push the rod firmly back into the barrel.

Important To Note:

When using the gun with a cartridge, the follower cup must be folded back.

The gun is supplied standard with the follower cup in this position.

B: Bulk Grease Loading:

Unscrew the grease barrel from the gun head & insert the barrel into the bulk grease.

Suck the grease up into the barrel by pulling the rod all the way back. When barrel

is full with grease, rescrew the barrel assembly back onto the gun head so that

the follower sits well against the grease. Press the clamp down & push the rod

firmly back into the barrel.

Important To Note:

When using the gun with bulk grease, the follower cup must be folded forward.

To do this, take the follower cup and rod assembly out of the barrel, fold the follower

cup forward and reassemble the barrel assembly.

Maintenance

Cleaning: always keep the follower cup free of impurities. Your grease should be clear

of any foreign particles, dirt etc and the gun should be checked and cleaned regularly.

Trouble Shooting

Air Pocked In Grease: If the gun is pumped but no grease appears from the coupler:

1: Depress the air bleeder valve on the head and pump a few strokes.

Unscrew the barrel assembly from the gun head with two or three turns and then push

on the plunger rod. With the follower cup engaged the follower cup will move further down

into the barrel venting any trapped air out through the thread connections between the barrel

and head. Unscrew the rigid extension as well.

Safety Warning

Always use safety goggles and gloves when operating this grease gun. Personal injury may occur and if so seek immediate

medical attention. Do not use a high pressure grease fitting as a loader fitting. Excessive pressure can cause personal injury

and equipment damage.

NSW/ACT

QLD/PNG

TEL: (02) 9677 1555

TEL: (07) 3204 9166

FAX: (02) 9675 1155

FAX: (07) 3204 1224

OWNER'S MANUAL

Lever Action Grease Gun

400g Grease Cartridges, Suction loading, Bulk loader pump from bulk grease drum.

Up to 12,000psi grease pressure

1.9g per stroke

VIC/TAS

TEL: (03) 8787 8288

FAX: (03) 8787 8266

Visit our website at

www.alemlube.com.au

SA/NT

TEL: (08) 9302 4199

TEL: (08) 8241 7111

FAX: (08) 9303 2095

FAX: (08) 8241 7011

www.alemlube.co.nz

200A

December 2021

TEL: (09) 447 1007

FAX: (09) 447 1008