Bosch Benchmark Series Service-Handbuch - Seite 30

Blättern Sie online oder laden Sie pdf Service-Handbuch für Backofen Bosch Benchmark Series herunter. Bosch Benchmark Series 45 Seiten. Built-in wall ovens
Auch für Bosch Benchmark Series: Service-Handbuch (36 seiten), Installationshandbuch (32 seiten), Kurzreferenz-Handbuch (4 seiten), Installationsanleitung Handbuch (40 seiten), Schnellstart- und Sicherheitshandbuch (13 seiten)

Seite drucken
Bosch Benchmark Series Service-Handbuch
58300000181895 ARA EN A
10. If necessary, slide the oven back into the cutout and reinstall trim.
6.7.3

Replacing the Convection Fan Motor

1. Follow steps 1-3 in the Replacing the Convection Fan Blade
section.
2. Remove the washer located behind the blade and set aside.
3. Remove the screws securing the right and left side trim pieces to
the cabinetry.
4. Carefully slide the oven out of the cutout to gain access to the
motor from the rear of the unit.
5. Remove the rear housing panel.
6. Disconnect the wires from the motor terminals.
7. Remove the screws securing the fan motor.
8. Three sheet metal tabs hold the motor in position after the screws
are removed; bend the tabs outward, using a flat blade
screwdriver or pliers, then remove the motor.
Figure 45 Sheet metal tabs for securing convection fan motor to rear of oven
9. Install the new motor, being sure to bend the three sheet metal
tabs back in.
10. Reinstall the fan blade and baffle.
11. Restore power and test operation.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
JUNE 2014
6.8
The 240V 3800W broil (upper) element is attached to a reflector,
which helps to direct the heat evenly toward the food.
Refer to the Element Strip Diagram section to test the broil element at
the control module. A Broil Element Relay Test is also available in
Service mode. See the Service Mode section for details.
If the wires are disconnected from the element terminals, an
ohmmeter can be used to check for resistance of ~15 ohms.
6.8.1
1. Remove power to the oven.
2. Detach the element from the reflector.
3. Remove the two screws from the terminal area on the rear cavity
wall.
4. Pull the element forward carefully (there is not much excess wire)
so that the terminal connections move inside the cavity.
5. Disconnect the wires from the terminals, being careful not to let
the harness wires drop back out of reach.
 If the wires are too short to disconnect from the front, continue
 If the wires were successfully disconnected, skip to step 8.
5. Remove the screws securing the right and left side trim pieces to
the cabinetry.
6. Carefully slide the oven out of the cutout to gain access to the
element terminals from the rear of the unit.
7. Disconnect the wire leads from the terminals.
8. Install the new element.
9. Restore power and test operation.
10. If necessary, slide the oven back into the cutout and reinstall trim.
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch Benchmark Series Built-in Wall Ovens

Broil Element

Replacing the Broil Element

with step 5.
Page 30 of 45
800 944-2904