AirStage UTB-*V Betriebshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Fernsteuerung AirStage UTB-*V herunter. AirStage UTB-*V 7 Seiten. Air conditioner remote controller (wireless type)

Seite drucken

To set the SLEEP timer

Unlike other timer functions, the SLEEP timer is designed to set the duration of time in which the unit does not operate.

The SLEEP timer can be set regardless of whether the indoor unit is operating or stopped.

(Both the indoor unit's OPERATION indi-

cator lamp (red) and the TIMER indicator

lamp (green) will light.)

To change the timer settings

NOTES

(1) PROGRAM timer

• The PROGRAM timer allows you to integrate OFF timer and ON timer operations in a single sequence.

• The first timer function to operate will be the one set nearest to the current time.

(2) SLEEP timer

To prevent excessive warming or cooling during sleep, the SLEEP timer function automatically modifies the set temperature in

accordance with the time setting. When the set time has elapsed, the air conditioner completely stops.

During heating operation:

When the SLEEP timer is set,

the set temperature is auto-

matically lowered 1 °C every 30

minutes, until the set tempera-

ture is lowered a total of 4 °C.

SELECTING THE SIGNAL CODE

When two or more air conditioners are installed in a room and the remote

control unit is operating an air conditioner other than the one you wish to set,

change the signal code of the remote control unit to operate only the air con-

ditioner you wish to set (four selections possible).

When two or more air conditioners are installed in a room, please contact

your retailer to set the individual air conditioner signal codes.

To select the remote control unit signal code

The air conditioner cannot receive a signal code if the air conditioner has not been set for the signal code.

Press until only the clock is

displayed.

NOTES

(1) If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original clock display. In this

case, start again from step 1.

(2) The remote control unit resets to signal code A when the batteries in the remote control unit are replaced. If you use a signal code other

than signal code A, reset the signal code after replacing the batteries.

If you do not know the air conditioner signal code setting, try each of the signal codes (

the air conditioner.

The OFF time is displayed

when the "M" mark is flash-

ing.

SLEEP timer setting

1 °C

2 °C 3 °C

4 °C

30 min.

60 min.

90 min.

Set time

Press for more than 5 sec-

onds to display the current

signal code. (Initially set to

)

To cancel the TIMER

Select "TIMER RESET".

The air conditioner will re-

turn to normal operation.

During cooling/dry operation:

When the SLEEP timer is set,

the set temperature is automati-

cally raised 1 °C every 60 min-

utes, until the set temperature

is raised a total of 2 °C.

Change the signal code be-

tween

to match the

code on the display to the air

conditioner signal code.

En-4

Adjust the OFF time.

(About 5 seconds later, the

entire display will reappear.)

To stop air conditioner

operation during

timer operating

SLEEP timer setting

Set time

60 min.

1 °C

To operate only

one of multiple

air conditioners

Press again to return to the

clock display. (The signal

code will be changed.)

) until you find the code which operates

2 °C