BD Simex RS-232 Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Medienkonverter BD Simex RS-232 herunter. BD Simex RS-232 12 Seiten. Converter module

User manual for RS-232 to RS-485 converter module PMT-2/4-Z45

1. BASIC REQUIREMENTS AND USER SAFETY

- The manufacturer is not responsible for any damages caused by

inappropriate installation, not maintaining the proper technical condition and

using the unit against its destination.

- Installation should be conducted by qualified personnel. During installation all

available safety requirements should be considered. The fitter is responsible for

executing the installation according to this manual, local safety and EMC

regulations.

- The unit must be properly set-up, according to the application. Incorrect

configuration can cause defective operation, which can lead to unit damage or an

accident.

- If in the case of a defect of unit operation there is a risk of a serious threat to

the safety of people or property additional, independent systems and

solutions to prevent such a threat must be used.

- Neighbouring and mating equipment must meet the requirements of appropriate

standards and regulations concerning safety and be equipped with adequate anti-

overvoltage and anti-interference filters.

- Do not attempt to disassemble, repair or modify the unit yourself. The unit

has no user serviceable parts. Units, in which a defect was stated must be

disconnected and submitted for repairs at an authorized service centre.

- In order to minimize fire or electric shock hazard, the unit must be protected

against atmospheric precipitation and excessive humidity.

- Do not use the unit in areas threatened with excessive shocks, vibrations, dust,

humidity, corrosive gasses and oils.

Do not use the unit in explosion hazard areas.

- Do not use the unit in areas with significant temperature variations, exposed to

condensation or icing.

- Do not use the unit in areas exposed to direct sunlight.

- Make sure that the ambient temperature (e.g. inside the control box) does not

exceed the recommended values. In such cases forced cooling of the unit must be

considered (e.g. by using a ventilator).

The unit is designed for operation in an industrial environment and must not

be used in a household environment or similar.