Electrolux EPPWEHGFB Handbuch - Seite 27

Blättern Sie online oder laden Sie pdf Handbuch für Waschmaschine Electrolux EPPWEHGFB herunter. Electrolux EPPWEHGFB 28 Seiten.

Seite drucken

The message "CLE" ("CLEAN") will be displayed

throughout the drain cycle:

CLE

•

After a few minutes, 3 beeps indicate the end of

thecleaning cycle and "END" blinks on the display:

End

•

Switch off the appliance by pressing button "A"

(Table 2 "Control panel").

•

Switch off at the mains.

•

Close the water supply cock.

•

Before operating the appliance again, replace the

components that have been removed.

Cleaning the nozzle jets

•

Remove the upper and lower wash arms "F" and

rinse arms "I", undoing the ring nut "H" (Figure 25).

Figure 25 Rotating wash arms and rinse arms

•

Unscrew plugs "L" (Figure 25) from the rinse jets.

IMPORTANT

Descale the rinse jets "I" (Figure 27) every month

using vinegar or a descaling agent.

•

Remove jet "P" (Figure 26) by turning it clockwise

and pulling it out.

•

Unscrew plugs "R" (Figure 26) from the side jets.

Figure 26 Fixed wash arm removal

•

Carefully clean the washing and rinse jets and

clean everything with hot water and neutral deter-

gent/detersive, if necessary using a soft brush or

sponge. In particular, for the jet "P" (Figure 27) use

warm water and detergent, and a soft brush "Z" if

necessary (Figure 27). Do not use sharp imple-

ments to clean the nozzle holes, which could

otherwise be damaged.

Figure 27 Fixed wash arm cleaning

Cleaning the wash pump filter

•

Remove the filter "E" and clean away any remained

food.

Upon completion of cleaning operations, replace the

parts removed previously.

J8.2

Exterior cleaning

Before carrying out any cleaning operations, turn off

the power at the mains.

IMPORTANT

Clean the stainless steel surfaces using warm

soapy water; never use detergents containing

abrasive substances nor steel scrapers, common

wire wool, brushes or scrapers; rinse thoroughly

using a wet cloth and carefully wipe dry. Clean the

control panel using a soft damp cloth and a neutral

detergent if necessary.

To reduce the emission of pollutants into the environ-

ment, clean the appliance (externally and where

necessary internally) with products having a biodegra-

dability of over 90%.

Leave the hood raised whenever the appliance is not in

use.