Bosch HBG56B5 0J Series Gebrauchsanweisung - Seite 17

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Backofen Bosch HBG56B5 0J Series herunter. Bosch HBG56B5 0J Series 36 Seiten.

Seite drucken

Unscrew the retaining clips on the right and left. Lift the panel

and remove the brackets from the panel (fig. C). Take out the

panel.

Clean the panels with glass cleaner and a soft cloth.

Do not use sharp or abrasive materials or a glass scraper. This

may damage the glass.

Fitting

When fitting, make sure that the lettering "right above" is upside

down at the bottom left.

Troubleshooting

Malfunctions often have simple explanations. Refer to the table

before calling the after-sales service as you may be able to

remedy the fault yourself.

Malfunction table

If a dish does not turn out exactly as you wanted, refer to the

Tested for you in our cooking studio section, where you will

find plenty of cooking tips and tricks.

Problem

The appliance does not work.

‹‹

appears in the display.

The oven does not heat up or the type of

heating selected cannot be set.

The oven does not heat up. A small

square lights up in the temperature dis-

play.

"‰

" appears on the display.

Error messages with

If an error message with

button. This cancels the error message. You may then have to

Error message

"‹‚‚

Possible cause

Defective fuse

Power cut

Type of heating not recognised

The oven is in demo mode.

Automatic switch-off has been

activated. The oven stops heating.

is shown in the display, press the

Possible cause

A button has been pressed for too

long.

Insert the panel diagonally towards the back (fig. A).

Stick the retaining clips onto the right and left-hand sides of

the panel, aligning them so that the carriers are over the

screw holes, and then screw in place (fig. B).

Insert the uppermost panel diagonally towards the back. The

smooth surface must face outwards.

Put the cover back in place and screw it on.

Attach the oven door.

Do not use the oven again until the panels have been

correctly fitted.

ã=

Risk of electric shock!

Incorrect repairs are dangerous. Repairs may only be carried

out by one of our trained after-sales engineers.

Note/remedy

Look in the fuse box and check that the circuit

breaker is in working order.

Reset the clock.

Make the settings again.

Switch off the circuit breaker in the fuse box, then

switch it back on after at least 20 seconds. Within

the next 2 minutes, press and hold the

for 4 seconds until the square disappears from the

display.

Press any button.

reset the time. If the error is shown again, call the after-sales

service.

You can take remedial action yourself if the following error

message is displayed.

Note/remedy

Press all buttons individually. Check that the but-

tons are clean. If the error message remains,

please contact the after-sales service.

button