Drazice TO 10.1 UP/IN Betriebs- und Installationshandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Betriebs- und Installationshandbuch für Warmwasserbereiter Drazice TO 10.1 UP/IN herunter. Drazice TO 10.1 UP/IN 14 Seiten.
Seite drucken
1 PRODUCT ACCESSORIES
The product is packed together with service instructions. The heater is equipped with a safety valve
as a protective element. The valve is mounted on the cold water supply (see chapter 7)
2 MESSAGE FOR CUSTOMERS
The water temperature is set by a thermostat to 55 °C. The electrical heater is designed for preparation
of hot water in households, cottages and various welfare facilities. It allows the installation of only one hot
water draw-off point with a pressure-free connection. In case of a pressure connection, it is possible
to connect more sampling points, but with limited use of simultaneous sampling. Its benefit is that it heats
up water by power in an unlimited all-day time range, due to small accumulation, the connection with HDO
signal control is not recommended. The time of heating service water is about 9 and 18 minutes, depending
on the volume.
3 TECHNICAL DESCRIPTION
The heater tank is steel enameled for pressure connection, the electrical heating element is of an immersion
type. The heater tank consists of magnesium anode that helps protect the heater tank from corrosion.
The heater tank is provided with polyurethane insulation and everything is stored in a plastic cover.
The electrical wiring is placed in the bottom (upper) part of the heater, under the removable cover
of the heater. The water temperature is set by a thermostat to 55 °C. The cold water inflow is indicated
with a blue ring, hot water outflow is indicated with a red ring.
TO 5.1, 10.1 UP - pressure heater with a capacity of 4.6 and 9.6 liters located above the consumption point
TO 5.1, 10.1 IN - pressure heater with a capacity of 4.6 and 9.6 liters located under the consumption point
The TO 5.1, 10.1 IN/UP heaters can also be used as non-pressure heaters.
- 4 -