Bosch Vision 800 Series Service-Handbuch - Seite 14
Blättern Sie online oder laden Sie pdf Service-Handbuch für Backofen Bosch Vision 800 Series herunter. Bosch Vision 800 Series 36 Seiten. Gas slide-in ranges
Auch für Bosch Vision 800 Series: Gebrauchsanweisung Handbuch (40 seiten), Abmessungen und Spezifikationen (2 seiten), Installationshandbuch (6 seiten), Service-Handbuch (43 seiten), Installationsanleitung Handbuch (28 seiten)
Seite drucken
58300000194725 ARA EN B
6
SERVICE AND REPAIR: OVEN
CAUTION
Turn off the electrical power circuit to the range at the main
junction box before servicing this unit.
Turn off the gas supply using the shut-off valve.
For those checks requiring the use of electrical power, exercise
extreme care.
Sheet metal parts often have sharp edges. Avoid injury by
handling these parts with care.
6.1
Doors
The serviceable parts of the door include the handle, endcaps, outer
door glass/skin (service assembly), hinges (service kit with two dual-
spring hinges), middle glass, 2-pane glass pack, porcelain-coated
door liner, and the various fasteners.
NOTICE
IMPORTANT INFORMATION: REASSEMBLING DOOR AFTER SERVICING
Be sure insulation is tucked in close to the glass pack. Insulation
should not block the hinge foot openings, or be visible through
the openings in the door liner after reassembly.
To avoid stripping the door liner screws or chipping the porcelain,
set a low torque setting when using a drill/driver.
When reinserting the screws which secure the door liner to the
rest of the door assembly, apply pressure to the liner to
compress the insulation inside the door while inserting the center
screw in the bottom edge of the liner first. Continue pressing on
the liner while reinserting the remaining bottom screws. Lastly,
reinsert the (4) screws/o-rings into the face of the door liner.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2016
6.1.1 Addition of Flat Springs to Door Assembly
Ranges with an FD 9502 and later include a flat spring on each side
of the inner door, between the middle glass bracket and the inner door
frame. The pressure of the flat springs against the brackets prevents
the glass from moving and rattling.
To resolve a report of rattling sounds in the door of a range with an
FD prior to 9502, order Flat Spring Service Kit 00635045. Instructions
are included in the kit.
6.1.2
CAUTION
Avoid injury when removing and replacing oven doors.
Be sure range is cool enough for handling.
Position hinges properly (see Figure 5).
Grasp door only by sides, not by the handle.
Do not force door open or closed.
Handle with care–the door weighs approximately 40 lb.
To remove the door...
1. Open door completely.
2. Flip right and left hinge levers back to open, as shown below;
be sure the levers are in the fully open position. (The RH and
LH hinges differ slightly, but operate in the same manner.)
Figure 7 Opening the hinge lever
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 800 Series Gas Slide-in Ranges
Removing and Reinstalling the Door
Page 14 of 36
800 944-2904