Bosch Vision 800 Series Service-Handbuch - Seite 17

Blättern Sie online oder laden Sie pdf Service-Handbuch für Backofen Bosch Vision 800 Series herunter. Bosch Vision 800 Series 36 Seiten. Gas slide-in ranges
Auch für Bosch Vision 800 Series: Gebrauchsanweisung Handbuch (40 seiten), Abmessungen und Spezifikationen (2 seiten), Installationshandbuch (6 seiten), Service-Handbuch (43 seiten), Installationsanleitung Handbuch (28 seiten)

Seite drucken
Bosch Vision 800 Series Service-Handbuch
58300000194725 ARA EN B
Figure 14 Removing inner support frame assembly
7. Lift the two pieces of insulation off the inner support frame
assembly and set aside.
8. Remove the screws securing the right and left side door
shields and set shields aside.
9. Carefully lift the glass pack out of the inner support frame.
Figure 15 Removing 2-pane glass pack
10. After removing and discarding all remnants of broken glass,
install the new glass pack assembly and reassemble the door.
11. Test operation of the door by fully opening and closing it
several times.
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
MAY 2016
1 Door side shield
2 Inner support frame
3 Two-pane glass pack
1
2
3
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 800 Series Gas Slide-in Ranges
6.2

Door Latch/Motor Assembly

The motorized door latch (MDL) mechanism (120VAC 60Hz 4.3W)
has 2 switches - the door switch and the lock/unlock switch. The latch
will automatically lock when mode and temperature selectors are set
to Self Clean, and unlock when the oven cools to ~490°F (255°C). The
latch and motor are serviced as an assembly.
Figure 16 Oven door latch
If the latch becomes stuck in the locked position, turning the unit off
and back on will open the latch if the cavity temperature <491°F. If
latch is stuck in a partially locked position, turn the mode and
temperature selectors to Self Clean, then turn them to Off.
If these measures fail, run a thin wire or wire coat hanger in between
the door and the front face of the range. Figure 17 shows where to
position the wire between the latch hook (1) and the plunger (2). Slide
the wire to the left, pushing the latch hook left and releasing the latch.
2
1
Figure 17 Latch in locked position
Page 17 of 36
800 944-2904