Anchor AN-130U1+ Benutzerhandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner Anchor AN-130U1+ herunter. Anchor AN-130U1+ 6 Seiten.
Auch für Anchor AN-130U1+: Benutzerhandbuch (7 seiten)
Seite drucken
AN-130+ Speaker Monitor Owners Manual
BASIC SYSTEM OPERATION
The AN-130++ monitor is used to amplify the signal
from a microphone, electronic musical instrument or
line-level sources (MP3, cassette, CD, VCR, etc).
You'll need a connection cable and an AC outlet.
1. Place the AN-130+ in desired location
2. Set volume control on front of speaker to
minimum
3. Plug the power cord into a grounded 115 volt
outlet
(220 volt outlet for export model)
4. Plug a microphone into the MIC input jack, or an
audio source into a LINE IN jack
5. Turn the power switch on the rear panel "ON"
(red LED on front panel should light)
6. Adjust the volume, bass & treble controls to
desired levels
IMPORTANT: To avoid feedback, do not position
a microphone in front of speaker.
LINE IN
The line-level RCA input jacks may be used with audio sources such as
computers, VCR's, and cassette tape or compact disc players. The inputs may
be used for two separate sources, or they may be used to sum L+R stereo
outputs to a mono signal without the need for adapters.
MIC IN
An unbalanced, low impedance
microphone input is for use with the
MIC-90P or other mics that have a 1/4"
phone plug.
BACK PANEL OF AN-130U1+
LINE OUT
The unbalanced Line-out provides a combined signal of all inputs being used.
You can use this function to record your presentation or to "daisy chain" another
powered sound system to the AN-130+ for greater crowd coverage.
Note: This output is post source level; any volume fluctuations for a specific input
will affect the output signal level at this output.
MADE IN USA
SIX YEAR WARRANTY
POWER SWITCH
POWER CORD
NOTE: SEE PAGE 4
FOR WIRELESS RECEIVER
INSTRUCTIONS
2