BASIC SYSTEM OPERATION
NOTE: Batteries Must Be Installed Before Use!
1. Position the AN-Mini with the front/speaker facing toward
your audience
2. Connect a microphone to the one of the MIC jacks
(1/4" MIC jack or 3.5 mm PWR MIC mini jack)
3. Turn the AN-Mini Power/Volume Level knob on, the red
POWER LED will light and remain lit during operation
4. Set the microphone power switch to ON
5. Adjust the volume with the Power/Volume Level knob
IMPORTANT: To avoid feedback, do not position
a microphone in front of speaker.
PROBLEMS? Consult the troubleshooting section on
the back page of this manual.
AN-MINI PA SYSTEM
AN-Mini is a battery-operated handheld Public Address system that's
easy to set-up & operate. Before using the AN-Mini, you'll need to in-
stall the batteries as described below right.
If your unit is equipped with an RC-30 rechargeable battery kit, you
must charge the batteries completely before use (see page 3).
AN-MINI ACCESSORIES
MIC-50 – Handheld Microphone
Handheld microphone w/ 6' coil cord & 1/4" connector.
MIC-90P – Handheld Microphone
Dynamic, balanced, low impedance microphone w/ unidirectional
pick-up pattern & 1/4" connector. Comes w/ 20' cable, storage
case & mic clip.
HBM-MINI – Headband Microphone
Ultra-lightweight headband microphone w/ 3.5 mm mini plug
RC-30 – Rechargeable Battery Kit
Includes 10 rechargeable "AA" batteries and AC adapter/charger.
NOTE: See page 6 for wireless microphones
& UHF transmitters.
4
POWER LED LIGHT
ON BRIGHT: AN-Mini power is turned on
ON DIM: LED dims as battery power runs low
OFF: Replace or recharge batteries
CHARGE LED LIGHT
ON: Optional RC-30 rechargeable battery
charger plugged in and batteries charging
OFF: Rechargeable batteries fully charged
DC IN – INPUT JACK
Use ONLY with the DC charger
that comes in the optional RC-30
rechargeable battery kit
POWER / VOLUME LEVEL
1. Remove the battery compartment cover located underneath the control
back panel of the AN-Mini by pressing down the lock tabs of the battery
compartment cover
2. Slide out the battery pack from the AN-Mini battery compartment
3. Insert ten 'AA' size batteries (alkaline or RC-30 rechargeable batteries)
into the battery pack Position the ten battery tubes into the battery pack
by following the polarity labels on the battery pack
MIC BOOST BUTTON
Push to give your voice an added boost when
speaking to a larger crowd or in a noisy
environment
To return to normal use push the "MIC
BOOST" button again.
LINE IN – INPUT JACK
1/8" (3.5 mm) - For any line-level
signal source: iPod, MP3/tape/
VCR/CD/DVD players, musical in-
struments, etc.
LINE OUT – OUTPUT JACK
1/8" (3.5 mm) - Balanced, combined output of all active system inputs
Record your presentation or connect to another powered sound system
Post source level output; any volume fluctuations for a specific input
will affect this output signal level
BATTERY INSTALLATION
4. Slide-in the battery pack into the battery compartment Push the battery
pack all the way in
5. Replace the battery compartment cover and push cover to lock tabs
in place
WIRELESS RECEIVER INSTRUCTIONS
SEE PAGE 6
POWERED MIC
1/8" (3.5 mm) - Phantom
powered for electret condenser
microphones that require
phantom power
MIC - INPUT JACK
1/4" Phone - Unbalanced,
low impedance,
no phantom power
Seite drucken