Anchor CA-130U1 Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Redner Anchor CA-130U1 herunter. Anchor CA-130U1 4 Seiten. Powered speaker monitor

Seite drucken

DIVERSITY WIRELESS BY ANCHOR AUDIO

Anchor Audio UHF wireless is a 16 channel, diversity wireless system that utilizes two independent antennae

to receive signals. The diversity feature means the receiver will process the stronger of the two antenna signals,

effectively minimizing dropouts and interference from other transmitting sources. The antennae are mounted

internally so there are no obstructions or risk of damage.

CHANNEL SELECTION - BUILT-IN RECEIVER

Before you can use your UHF wireless system, you will need to select a wireless frequency, set the built-in receiver,

and microphone transmitter, to that channel.

1. Choose from any of the 16 available wireless channels

2. Set the wireless channel selector knob "CHANNEL" to the channel/frequency you have chosen

If you have two wireless receivers repeat above for the second receiver. Remember each receiver/transmitter pair

must be set to different channels to work properly.

CA-130U1

BUILT-IN UHF WIRELESS

RECEIVER CONTROLS

NOTE: If you experience ongoing interference with your wireless system,

the selected frequency may be incompatible w/ other systems

in the area. Try different channels to find a clear frequency.

UHF WIRELESS ACCESSORIES

WH-6000: 16 channel wireless handheld microphone/transmitter

WB-6000: 16 channel wireless body-pack transmitter for hands free microphone

(microphone not included – see below)

CM-60:

Lightweight, low-profile collar microphone – works w/ the WB-6000 transmitter

EM-60:

UltraLite "Over-the-Ear" hands free microphone – works w/ the WB-6000 transmitter

LM-60:

Lightweight, clip-on lapel microphone – works w/ the WB-6000 transmitter

HBM-60:

Ultra-lightweight headband microphone – works w/ the WB-6000 transmitter

UHF WIRELESS

VOLUME CONTROL

UHF WIRELESS

CHANNEL SELECTION

RX INDICATOR LIGHTS

Feedback is a howling noise or shrill sound that is self-generated by the sound system. It is caused by a micro-

phone picking up the sound coming from the speaker and then being re-amplified. Once a feedback loop is

started it will continue until the system is adjusted.

FEEDBACK CAUSES

• Microphone too close, pointing towards or in

front of the speaker

• Volume setting too loud for room

• Sound reflections from hard surfaces, walls, etc.

CAUTION: Feedback can damage your equipment & may be hazardous to hearing.

WIRELESS REMOTE CONTROL

REMOTE OPERATION

Point the red Mute button towards the front of the

CA-130U1, aiming the remote at the red window

located near the Volume and Tone controls.

• Raise volume by pressing Volume Up

• Lower volume by pressing Volume Down

• Mute system by pressing Mute

• Stop mute by pressing Mute again or

pressing either volume button

NOTE: If the system is not responding be sure the signal is not blocked.

REPLACING THE REMOTE BATTERY

1. Locate the latch on the bottom of the

remote, near the back

2. Gently pull the latch towards the center

of the remote

3. Slide out the battery holder carefully

4. Place a new battery in holder with positive

symbol on the battery facing up

5. Carefully re-insert the battery holder

NOTE: Use only CR2025 or CR2032 type batteries.

FEEDBACK

AVOIDING & ELIMINATING FEEDBACK

• Point the microphone in a different direction

• Keep the microphone away from the speaker;

position speaker in FRONT of microphone

• Reduce the sound system volume levels

VOLUME

DOWN

VOLUME UP

BATTERY

REMOTE CONTROL

BOTTOM

MUTE

BATTERY

HOLDER