Anchor Navi-Trac Lite Installationsanleitung Handbuch - Seite 16

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Zelt Anchor Navi-Trac Lite herunter. Anchor Navi-Trac Lite 20 Seiten. Frame tent 30' wide system

Seite drucken

Gabled End Frames

R-30

If you plan to use the gabled end frame on either end of the unit,

it will be easier to install the Gabled End Uprights (GU) and the

Gabled End Rafter Fittings (GFL and GFR) while that end beam

GFR

is still on the ground. On the 30' Frame, the top fitting on the

GU must be slid out of the upright so it is pinned in the second

hole.

PEAK

Notice that the Rafter Fittings (GFL and GFR) lap the beam and

GFR BOLT

bolt through the beam side-to-side (on the under side of the

& NUT

beam in the photo to the right). Be sure to bolt the fittings thru

the side of the end beam that faces the "inside" of the structure.

This prevents interference with the Gabled End Fabric Panels

which will feed into the lower channels of the end beam facing

PURLIN BRACKET

the "outside" of the structure. In fig. 48, we are viewing the "out-

side" facing of the beam.

Caution: If you will be using Gabled Ends on both ends of

your unit, please refer to the section on Frame safety for

OUTSIDE FACE OF BEAM

Gabled Ends on page 17.

Gabled End Frame Assembly

If the End Uprights were not installed while the end beam was on the ground, they will have to be installed from a ladder. (See fig. 48 for

correct installation of the End Rafter Fittings).

Next, drop in the curved, hook end of the end mid-eave bar on an end upright bracket (fig. 49). Then, using the eave bar cradle, drop in

the angled end on the other upright (fig. 50).

Install the hooked bar connector of the endwing eave bar into the corner upright bracket (fig. 51). Then, drop in the angled end on the

remaining bracket of the end upright (fig. 52). Repeat this process for the opposite end wing eave bar, then stake down the uprights.