Electrolux 506029 Handbuch - Seite 9

Blättern Sie online oder laden Sie pdf Handbuch für Geschirrspüler Electrolux 506029 herunter. Electrolux 506029 20 Seiten. Warewashing hot water sanitizing pot and pan washer – 34.50′′ wt830
Auch für Electrolux 506029: Spezifikationsblatt (2 seiten)

Seite drucken

INSTALLATION AND START-UP INSTRUCTIONS

A fused disconnect switch or a main circuit breaker

(customer furnished) MUST be installed in the

electric supply line for the appliance. It is recom-

mended that this switch/circuit

lockout/tagout capability. Before making any electri-

cal connections to this appliance, check that the

power supply is adequate for the voltage, amperage,

and phase requirements on the rating plate.

RATING PLATE

The rating plate contains identification and technical

data and is located on the right-hand side panel of the

appliance (Figure 7).

Figure 7

WATER CONNECTION

•

Position the potwasher and level the appliance by

adjusting the appropriate bullet feet (Figure 7).

•

Connect the appliance water supply pipe "A"

(Figure 4/Figure 5/Figure 6)

plumbing codes) to the incoming water supply. Install

a shutoff valve, Y-Strainer and a pressure gauge

between the appliance and the incoming water sup-

ply of the unit (Figure 8).

Figure 8

•

Check that the dynamic water supply pressure

measures between 7.25 - 101 psi/50 - 700kPa while

potwasher tank or boiler is filling with water.

breaker have

Model PW1M

PNC 9CGX 506029 05 Ser.N .123000001

AC 400V 3N

50Hz

Power Boiler

10500w

Power Tank

12000w

Power Max

22000w

Made in EU

Model PW1M

PNC

9CGX506029 05

Ser.N .123000001

(keeping

with

local

If the pressure is too high, install a suitable pressure

regulator on the incoming water supply to the unit.

On models with free-fall drainage:

connect the waste outlet pipe "C" (Figure 4/Figure 5/

Figure 6) to the main drain pipe, using a trap, or place

the outlet pipe over an "S" trap set into the floor.

On models with drain pump:

position the outlet pipe at a height anywhere between 29

1/2" to 39 3/8"/750 and 1000 mm from the floor.

Check that about 1 gallon/4 litres of water flow out of the

outlet pipe during the rinse cycle.

Make sure drain hose does not kink, pinch or twist,

resulting in a water flow restriction.

ELECTRICAL CONNECTION

A C

Figure 9

CAUTION

THE ELECTRICAL CONNECTIONS MUST

MEET ALL NATIONAL AND ELECTRICAL

CODE REQUIREMENTS.

The installation of this unit must conform to local

codes or, in the absence of local codes, to all Natio-

nal Codes governing plumbing, sanitation, safety

and good trade practices.

•

Check the over rating plate before making any

electric supply connections. Electric supply connec-

tions must agree with data on the unit rating plate.

•

The earth wire at the terminal end must be

3/4"/20 mm (max.) longer than the phase wires.

•

The appliance requires a ground connection to the

unit ground screw located at the rear of the unit

marked

"Q"

(Figure 4/Figure 5/Figure 6)

manual and marked with the symbol "

. .

8 . .

2 0

the

" on the unit.