Carlson BRx7 Handbuch

Blättern Sie online oder laden Sie pdf Handbuch für Empfänger Carlson BRx7 herunter. Carlson BRx7 2 Seiten.
Auch für Carlson BRx7: Kurzanleitung (2 seiten)

Seite drucken

This is in regards to using SurvCE 6.08 or higher to configure a BRx7 base / rover for RTK using the UHF

radios while at the same time logging raw static to your BRx7 base for post-processing.

Here is the instructions for connecting a BRx7 base and rover using the internal UHF radios:

1) Power on your BRx7 base and then tap Equip / GPS Base and set it for

Manufacturer: Carlson and Model: BRx7

2) Tap the "Comms" tab and set it for "Type: Bluetooth" and "BT Type:

Windows Mobile" and tap the "wrenches" icon to the right. Tap "Find Device"

and follow the prompts to select the serial number of your BRx7 base then

tap the Bluetooth plug icon in the top middle

3) Then tap the Receiver tab and tap next to "Slant" and measure up to

the line where the top Blue cap meets the bottom Grey housing as shown

in the image to the right with the Arrow symbol to use for your Antenna

height

To log raw data at your Base

tap the "Advanced" button while in the Receiver tab of the GPS Base

dialogue then check the box for "Log Raw Data to Receiver" and tap the

green check to save your changes

5) Attach the silver metal bracket to the bottom of the BRx7 base then

attach the short cable to the UHF port. Then connect the UHF antenna to

the bracket so it points straight up in the air.

6) Tap the RTK tab and set it for "Device: Internal Radio" and "Message

Type:

RTCM

V3.2"

7) Tap the "wrenches" next to "Device: Internal Radio" and fill out the

radio using the settings below then tap the Green Check:

Protocol: Satel

Power: 1 watt

Channel: 1: 0 Mhz

New Channel Frequency: 461.0000

Channel Spacing: 25khz

Forward Error Correction: Checked on

***If you have an FCC licensed frequency or a custom frequency you want

to use you can type this into the "New Channel Frequency" box and it will

program Channel #1 to the new frequency.

8) Tap the Green Check and use one of the options in the

"From New Position" or the "From Known position" to start the GPS base

This document contains confidential and proprietary information that remains the property of Carlson Software Inc.

Page 1 of 2

Carlson Software Inc.

while you are using your GPS Rover

33 East 2

Street

Phone: (606) 564-5028

Maysville, KY 41056

Updated 12/14/2020

www.carlsonsw.com

Fax: (606) 564-6422