Formax COMBI 0030 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Aktenvernichter Formax COMBI 0030 herunter. Formax COMBI 0030 8 Seiten. High-security paper shredder & optical media destruction device

Seite drucken

4. Jam Indicator

: LED lights when too much paper has been inserted at once. The Auto Reverse function will

engage, the cutting blades will stop, run in reverse, and stop. Gently remove the paper, and separate to feed in

smaller stacks. This LED will also light when there is still material in the feed slot when the door is opened or when

the machine is switched on.

5. Oil Indicator

: LED lights when the cutting blades are in need of oil. No action is needed from the operator,

because the EvenFlow

6. Door Open

: LED lights when the cabinet door is opened. The shredder will switch off automatically and cannot

be restarted until the door is closed. LED will flash if there is an electrical fault in the door sensor. Contact Dealer for

service, if needed.

7. Motor Overload

restarted while the motor is cooling down. LED will flash if there is an electrical fault inside the control board. At the

same time, the Ready/Off/Stop LED will flash. The shredder will switch off. Contact Dealer for service, if needed.

8. Waste Bin Full

: LED lights when the paper waste bin is full and must be emptied. Cutting blades will stop moving.

Operation: Paper Shredder

WARNING: For paper only. No CD's, DVD's, Blu-ray discs,

credit cards, staples, or paper clips.

1. Press main toggle switch to Paper Shredder ON.

2. Press Ready button, the green LED will light.

3. Load paper into shredder infeed slot, up to 8 sheets

(70gsm). The photoelectric sensor in the infeed slot will

signal the cutting blades to start automatically.

4. When shredding is complete, the blades will stop moving. You may also press the

Stop button at any time. NOTE: The unit will go into sleep mode and turn itself off

after approximately 5 minutes. Simply press the Ready button to resume shredding.

5. To shred paper that is not recognized by the light sensor (i.e. transparent films), press and hold the Forward button

for approximately 2 seconds. The blades will run continuously until the Stop button is pressed.

Emptying the Waste Bin: Paper Shredder

The paper waste container should be emptied periodically and/or when the Waste Bin Full LED is lit. Open the cabinet

door, remove the waste bin and empty the contents. Replace the bin and close the door.

EvenFlow

Automatic Oiling System (Paper Shredder Only)

The Automatic Oiling System periodically pumps oil onto the paper

cutting blades for optimal performance.

To install the oil reservoir bottle, unscrew and remove the cap from

a full bottle of oil, insert the hose from the shredder into the top of

the bottle, and screw on the hose/cap assembly.

The oiler is now ready for use.

Automatic Oiling System will apply oil to the blades.

: LED lights when the motor has been overloaded and has switched off. The shredder cannot be

Paper Shredder In-feed

Hose & cap assembly

Oil reservoir bottle

Photoelectric Sensor