Alentec & Orion 24720 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Messgeräte Alentec & Orion 24720 herunter. Alentec & Orion 24720 8 Seiten. In line meter

Manual 24720_EN_2B

Then press <SELECT> and the display will move on to

received volume input. The first figure will "blink" to

show that it is changeable. Press <RESET> to change

the value press <SELECT> to change to the next figure.

In this example we received 1.6852 L so we move to

second figure with <SELECT> and change it from 5 to

6 with <RESET> move to third figure and change it

from 6 to 8 and so on.

When the last figure is blinking and <SELECT> is

pressed the display will change to show the calculated

calibration factor. If <RESET> is pressed the new

calibration is cancelled.

If <SELECT> is pressed the calibration is saved and

then the meter goes back to normal dispense mode. The

calibration is done.

If the calculated factor exceeds +/- 10% the error

message "E3" will be shown for a while and then it will

go back for a new calibration dispense.

5.2. Unit used for measuring

The meter can be set to use either [L]itre, [G]allon, [P]int or [Q]uater. The unit used is shown after the value.

5.2.1.

Press <RESET> and <SELECT> buttons simultaneous

and hold them down for 5 s. If successfully done the

display will change to this, showing that the meter is in

configuration mode. Now release the buttons.

Press <SELECT> button to get into "Set unit" mode. The

display will change to.

Scroll through the different units using the <RESET>

button. L, G, P, Q, L,...... . When the wanted unit is

shown release all buttons and wait. The will save and go

back to "ConF" after a short time.

To get back to normal operation mode wait a short time

or press <RESET> button. When the display looks like

this it is done.

◄ ▬ ►

▬ ►

WAIT!

6(8)