Common Sense RC LECTRON PRO Anweisungen - Seite 2
Blättern Sie online oder laden Sie pdf Anweisungen für Kamera-Zubehör Common Sense RC LECTRON PRO herunter. Common Sense RC LECTRON PRO 2 Seiten. Basic nickel-metal hydride (nimh) battery
Auch für Common Sense RC LECTRON PRO: Manuallines (2 seiten), Manuallines (2 seiten)
Seite drucken
7) Unless you are using the battery pack in a pre-approved application (a stock vehicle we recommend the pack for),
use a wattmeter to test the current draw in your application. Remember, this is an aftermarket pack, and unless
you test it, you don't know if you're pulling too much current out of the pack. If you are planning to run the pack
in more than one application, measure each of them.
8) Register your battery pack with Common Sense RC by using the Battery Registration tool on our website. It's found
on the Product Instructions page at www.commonsenserc.com/page.php?page=warranty_form.html.
9) Make sure that your ESC is set up for a low-voltage-cutoff of 3.2V/cell or higher. Discharging the battery below 3.2V
per cell can result in permanent damage to the battery and will void the warranty.
10) Go run the pack! Enjoy it, and if you like it, tell your friends!
11) Allow the battery to cool down, and look over the pack to make sure it hasn't been physically damaged, particularly
if you've just crashed!
12) Charge and balance the pack.
13) Repeat steps 10-12 until you've had as much fun as you can stand.
14) If you won't be using the battery for more than a week or so, it should be stored at 40-50% charged (3.80V - 3.90V
per cell).
lECTRON PRO BATTERY PACk lIMITED WARRANTY:
• This Lithium Polymer Battery Pack is guaranteed, under warranty, against defects in materials and workmanship for
one year from the date of purchase.
• This warranty does not cover physical damage to the battery pack as the result of a crash, hard landing, improper
mounting or any deformity caused by the user.
• This warranty does not cover internal damage to the battery pack due to overcharging, deep discharging, excessive
discharge current, or improper storage.
• In order to be eligible for warranty exchange, the user must follow the initial setup instructions above, and the pack
must be registered with Common Sense RC.
• As a courtesy to our customers, we will also exchange any physically damaged battery pack for a new one at 85% of
the original purchase price.
• This warranty is non-transferable and applies only to the original purchaser of this battery pack. Any transfer of
ownership will void the warranty.
lECTRON PRO lIThIUM POlYMER BATTERY SAFETY WARNINGS:
• Use caution to avoid puncture of the cells. Puncture of cells may cause fire.
• If at any time you witness a battery starting to balloon or swell up, discontinue the charging or discharging process
immediately. Disconnect the battery and observe it in a safe place for approximately 15 minutes. Dispose of the pack
following the instructions below. Continuing to use a battery that has begun to swell may result in fire.
• Do not attempt to solder connectors to Lithium Polymer batteries unless you have experience soldering wire leads
on LiPo or LiFe batteries. To solder a connector, remove any protective insulation on the red wire and solder to the
positive terminal of a connector, then re-insulate that terminal using shrinktube. Next, remove any protective
insulation on the black wire and solder to the negative terminal of the connector, then re-insulate that terminal. Be
careful not to let the uninsulated portions of the wire leads touch each other, as this will cause a short circuit and
potential fire. If you accidentally cause the battery to short, place it in a safe open space and observe the battery for
approximately 15 minutes. A battery may swell or even possibly catch fire after a short time.
If, for any reason, you need to cut the terminal wires, cut each wire separately, ensuring the wires do not touch each
other, or a short may occur, potentially causing a fire. Additionally, if a short occurs and contact is made with metal
(such as rings on your hand), severe injuries may occur.
• You must check the pack voltage before each charging session. Do not attempt to charge any pack if the voltage of
any cell is less than 3.2V.
• Do not discharge battery to a level below 3.2V per cell under load. Deep discharge below 3.2V per cell can dramatically
deteriorate battery performance and will likely cause the battery pack to become defective and unusable.
• Batteries that lose 20% of their capacity must be removed from service and disposed of properly. For example, a
2000mah battery that behaves as if it is only a 1600mah battery is unsuitable for service. Dispose of it using the
instructions below.
lIThIUM POlYMER DISPOSAl INSTRUCTIONS
• To dispose of this battery please take it to your local electronic waste recycling center.
Toll-Free Phone: 866-405-8811 • International Callers: 818-718-1893 • Fax: 818-718-6742
Example: Do not charge a 2-cell pack if below 6.4V
Do not charge a 3-cell pack if below 9.6V
Common Sense RC • www.CommonSenseRC.com
lectronpro_instructions_v8_august_2017