Dreame U20 Benutzerhandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Staubsauger Dreame U20 herunter. Dreame U20 10 Seiten. Cordless stick vacuum

Dreame U20 Benutzerhandbuch
FAQ
EN
If the vacuum is not working properly, please refer to the table below.
Errors
Possible Causes
The appliance is out of battery or
its battery level is low.
The vacuum does not
Overheat protection mode
work.
triggered by a blockage.
The suction opening or air duct is
blocked.
The dust cup is full and/or filter
assembly is clogged.
Weak suction force.
An attachment is blocked.
The motor makes a
Main suction opening or extension
strange noise.
rod is blocked.
The battery indicator
is solid red when
The battery pack is damaged.
charging the vacuum.
The battery indicator
The motor temperature is too high.
blinks red after turning
/ The bush roller is blocked. / The
on the vacuum.
air duct is blocked.
The charger does not plug into the
vacuum well.
The battery indicator
The battery is fully charged
does not light up
and switches to sleep mode
when charging.
automatically.
The problem persists after ruling
out the above two possibilities.
The battery temperature is too low or
Charging too slow
too high.
LED lights of the multi-
surface brush do not
LED lights are damaged.
work.
The lithium-ion battery pack contains substances that are hazardous to the
environment. Before disposing of the vacuum, please remove the battery pack, then
discard or recycle it in accordance with local laws and regulations of the country or
region it is used in.
The appliance must be disconnected from the power supply when removing the
battery. Keep batteries out of the reach of children. Never put batteries in mouth. If
swallowed, contact your physician or local poison control.
Under abusive conditions, never contact the battery from which the liquid may be
ejected. If contact accidentally occurs, rinse with water. If liquid contacts eyes, seek
medical help immediately. Liquid ejected from the battery may cause irritation or
burns.
16
Solutions
Fully charge the vacuum, then resume
use.
Clean the suction opening or air duct.
Wait until the vacuum cools down, then
reactivate it.
Clear any blockage from the suction
opening or air duct.
Empty the dust cup and/or clean the
filter assembly.
Clear any blockage in the attachment.
Clear any blockage in the main suction
opening or extension rod.
Please contact the after-sales service
department for maintenance.
Check these parts in turn.
Check whether the charger is properly
plugged into the vacuum.
The vacuum runs normally.
Please contact the after-sales service
department for maintenance.
Wait until the battery temperature
returns normal, and then recharge.
Please contact the after-sales
department for maintenance.
WEEE Information
All products bearing this symbol are waste electrical and electronic equipment
(WEEE as in directive 2012/19/EU) which should not be mixed with unsorted
household waste. Instead, you should protect human health and the environment
by handing over your waste equipment to a designated collection point for
the recycling of waste electrical and electronic equipment, appointed by the
government or local authorities. Correct disposal and recycling will help prevent
potential negative consequences to the environment and human health. Please
contact the installer or local authorities for more information about the location as
well as terms and conditions of such collection points.
EN
17