Carmanah EG145 Benutzerhandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Beleuchtungsanlagen Carmanah EG145 herunter. Carmanah EG145 16 Seiten. Eg-series

Seite drucken

Testing the system

The EG-series Programmer can be used to test the
EG-series system. To test the system:
• Point the programmer at the IR transmitter/receiver
on the EG-series EMS.
• Press and hold the Test button on the programmer
until it beeps once.
• The LED fixture should turn on briefly to indicate
that the system is operating properly.
The test command may not be received by the
EG-series EMS on bright, sunny days. Try getting
closer to the EMS, or try testing later in the day when
the sunlight won't interfere as much with communica-
tions. See the Troubleshooting section if the fixture
still will not turn on.
8

EMS Indicator Lights

The EG-series EMS has three indicator lights which
are visible from the ground at night. On bright days,
the lights may be difficult to see from the ground,
and a pair of binoculars can be used to see the
lights (do not look at the sun directly when operating
binoculars).
The following table summarizes the behaviour of the
three EMS indicator lights:
Light symbol
Status
On (green)
Flashing (green)
Off
On (red)
Flashing (red)
Off
On (red)
DIM
Off
All 3 lights
Pulsing (all lights) Programming
© 2012, Carmanah Technologies Corporation. 63966_EG_Series_UserManual_RevB
EG-SERIES USER MANUAL
tEStING thE SyStEM
Function
Not charging
(night detected)
Charging (day
detected)
No battery
connected
Load low/high
voltage discon-
nect (Load LVD/
HVD)
Load over-current
Load OK
Dimming due to
battery low/high
voltage discon-
nect (Battery
LVD/HVD)
Time-controlled
dimming