CommScope BSAMNT-3 Anleitungsblatt - Seite 4
Blättern Sie online oder laden Sie pdf Anleitungsblatt für Racks & Ständer CommScope BSAMNT-3 herunter. CommScope BSAMNT-3 4 Seiten. For wide panel antennas
Seite drucken•
Loosen pivot screws . (do
not remove)
• Remove adjuster screws.
• Adjust antenna angle.
(use inclinometer)
• Reinstall adjuster screws.
Middle Bracket First
• Retighten all screws.
Remote Electrical
Tilt Connection
RF Cable Connection
The installation, maintenance, or removal of an antenna
requires qualified, experienced personnel. CommScope
installation instructions are written for such installation
personnel. Antenna systems should be inspected once a
year by qualified personnel to verify proper installation,
maintenance, and condition of equipment.
CommScope disclaims any liability or responsibility for the
results of improper or unsafe installation practices.
It is recommended that transmit power be turned off
when the field installation is performed. Follow all
applicable safety precautions as shown on this page.
www.commscope.com
© 2020 CommScope, Inc. All rights reserved.
Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.
All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639840 J (02/20)
M10 pivot screw
(loosen only)
E
M10 pivot screw
(loosen only)
Adjusting Antenna Tilt - 3 POINT MOUNT
(Not applicable for BSAMNT-F)
The AISG connector fitted to the antenna is designed to accept
any AISG compliant cable assembly, commscope recommends
hand tightening AISG mating connector only. Applied torque to
the connector shall not exceed 1.5N*m.
The female RF connectors fitted to the antenna are designed
to fit jumper cables with standard related male RF connector.
Tighten the RF connector coupling according to torque
specification in antenna label, if the RF connectors are
tightened beyond the recommend torque, the RF connection
to the antenna may be damaged.
SAFETY NOTICE
use inclinometer to
adjust antenna angle
M8 adjuster screw
perimeter location
(remove to adjust tilt)
Do not install near power lines.
Power lines, telephone lines,
and guy wires look the same.
Assume any wire or line can
electrocute you.
M10 pivot screw
center location
M10 pivot screw
(loosen only)
(loosen only)
M10 pivot screw
(loosen only)
DETAIL E
MAXIMUM TORQUE
M8
M10
M12
Do not install on a wet or windy
day or when lightning or thunder
is in the area. Do not use metal
ladder.
639840
25N.m (18ft.lbs)
40N.m (30ft.lbs)
58N.m (43ft.lbs)
Wear shoes with rubber soles and
heels. Wear protective clothing
including a long-sleeved shirt and
rubber gloves.
Page 4 of 4