ATI Technologies Q46S/66 Handbuch Kommunikation - Seite 13

Blättern Sie online oder laden Sie pdf Handbuch Kommunikation für Messgeräte ATI Technologies Q46S/66 herunter. ATI Technologies Q46S/66 18 Seiten.

ATI

Q46 Ethernet/IP Communications Manual

Once the assignment has been made and the IP has been sent to the

Q46, disconnect power to the Q46 and that IP will be stored in the

instrument. The Q46 stores the very last successful IP address

assignment. Then close out all BOOTP server windows.

Now, to check that the IP address has been properly saved, apply power

to Q46 again and make sure it is connected to PC Ethernet port. Do not

launch BOOTP server this time, as you don't need it.

Wait 1 minute, as Q46 will search for a BOOTP server for about 30

seconds on power up and won't find the service because you are not

using it here. It will then revert to the stored default – the last successful

BOOTP assignment. You can check the IP connection to the Q46 at that

address by entering a ping command at the Windows OS command

prompt, for example ">ping 192.168.0.30." You should see a response

as shown below. In addition, you can try and ">arp -a" command to show

all current connections and associated MAC addresses. You should see

the new IP address of 192.168.0.30 showing up.

Figure 8 – PING and ARP Command Tests for IP Address Setting.

Note that the "arp -a" listing still shows this IP as a "dynamic" assignment,