Andersen 12ST FS Handbuch - Seite 4
Blättern Sie online oder laden Sie pdf Handbuch für Winden Andersen 12ST FS herunter. Andersen 12ST FS 9 Seiten.
Seite drucken
Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the position
numbers in the parts list.
Tools required for the installation:
Allen key (4 mm.).
Allen key (5 mm.).
Ø6,5 mm. (1/4") drill.
6 pcs. M6 (1/4") countersunk head screws and nuts (length depending on deck thickness).
6 x large washers or backing plate.
Ring spanner to match nuts.
Bedding compound
1.
Remove screws (1).
2.
Remove self-tailing arm (2) and drum (4).
3.
Mark location of bolt holes using the template.
IMPORTANT: On this model the self-tailing arm (2) is fixed in one position.
Ensure correct positioning of the self-tailing arm, before marking and drilling the bolt holes.
4.
Remove base (13). Be sure that no dust comes into contact with the winch while drilling.
5.
Drill bolt holes Ø6,5mm (1/4").
6.
Apply a light coat of bedding compound, ensuring that each bolt hole is bedded.
Keep drain grooves clear.
7.
Fasten base (13) into place using 6 pcs. M6 (1/4") countersunk head screws. Use large
washers or a backing plate.
8.
Assemble in reverse order.
9.
Check that the winch is functioning correctly:
The drum should operate smoothly, by turning the drum clockwise by hand.
The drum must not turn when trying to turn the drum anti clockwise.
While turning the winch handle clockwise the drum should turn.
While turning the winch handle anti clockwise the drum should not turn.
INSTALLATION
12ST ver. 3.0 – 12ST FS ver. 1.0