Advanced Kiosks Enviro Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Digitale Beschilderung Advanced Kiosks Enviro herunter. Advanced Kiosks Enviro 20 Seiten.
Seite drucken
When mounting to the floor you should use no less than eight, Grade 5, ¼" diameter x 2" length
sleeve anchor bolts to secure the kiosk to your selected location's surface. We recommend the
following procedure:
1.
Remove the kiosk from the wood base by unscrewing the 8 bolts that hold the kiosk to
the base.
2.
Using ANSI standard drill bits, carefully drill holes in the base material using the base to
the kiosk as a guide for hole location. Hole size = Bit size when installing sleeve anchors. Make
sure the hole is always drilled 1/2" deeper than the sleeve anchor will penetrate the base material.
3.
Clean the hole of all debris made during drilling, using a brush, vacuum, or compressed
air. Debris can prevent secure mounting.
4.
Center kiosk over drill holes.
5.
Sleeve anchors come fully assembled with a nut and washer. It is important that the nut is
on the end of the threads to protect the threads during hammering.
6.
Insert the sleeve anchor through the mounting hole and into the hole you drilled in the
base material. A hammer will be required to pound the sleeve anchor into the material until the
washer and nut are tight against the kiosk.
7.
Tighten the nut until finger tight, always turning clockwise.
8.
Using a wrench or socket, turn 2-4 times until you are sure it is snug.
Enviro Kiosk Assembly and Operation Instructions
5
www.advancedkiosks.com
8/27/19