Communications Specialists R-1000 Betriebshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Empfänger Communications Specialists R-1000 herunter. Communications Specialists R-1000 12 Seiten. R-1000 telemetry receiver operating manual

Seite drucken

CPU RESET

Should the microprocessor "hang up" and need to be reset, this can be

done easily and without losing memory.

1. Press and hold [CLEAR] while turning receiver on.

2. Menu Programming will return to default settings of 5 second scan,

1.0 kHz steps, and beep on.

LAMP

The [LAMP] key will illuminate the display and keypad for use in

darkness.

1. Press [LAMP] to illuminate the display and keypad for 5 seconds.

2. Press and hold [LAMP] for 2 seconds to illuminate continuously until

[LAMP] is pressed again.

EARPHONE JACK

A 3.5mm (1/8") earphone jack is mounted on the top panel. When an

earphone or headphone is plugged in, the internal speaker in the receiver

is disconnected. If stereo headphones are used, only one side will be

active.

RECHARGING THE BATTERY

The receiver is supplied with both wall and cigarette lighter chargers that

plug into the side to recharge the batteries. A fully charged radio will

provide approximately 12 hours of operation at moderate volume. The

batteries should be charged overnight. Do not keep receiver on charger

any longer than two or three days.

USING ALKALINE BATTERIES

If "AA" alkaline batteries are installed in receiver, DO NOT plug either

wall or cigarette lighter charger into receiver. Remove at least one

alkaline battery if you choose to operate receiver directly off wall or

cigarette lighter charger without consuming battery power. If supplied

rechargeable batteries are installed, they may be left in while using wall

or cigarette lighter charger.