Andersen Verilock 0112786 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sicherheitssensoren Andersen Verilock 0112786 herunter. Andersen Verilock 0112786 16 Seiten. For a-series and 400 series windows and patio doors, 200 series patio doors and renewal by andersen windows

Seite drucken

Battery Replacement Instructions - continued

400 Series & A-Series Casement and Awning Windows

1. Move the window lock handle to the center

position. The sash can be open or closed.

2. Remove the lock handle with magnet.

3. Remove the VeriLock sensor assembly using a small

thin blade putty knife, taking care not to scratch the

wood or VeriLock sensor assembly (VeriLock sensor

assembly is located on the left-hand lock for awning

windows - as viewed from the interior). Remove the

VeriLock sensor assembly straight backwards being

careful not to damage the sensor.

4. Carefully remove the battery cap.

5. Remove discharged battery from the VeriLock

sensor assembly using a small flat blade

screwdriver to carefully pry the battery from the

terminal. (see battery disposal information on

page 5).

6. Replace the battery with (1) one fresh CR-2025

lithium coin cell battery with the positive (+) side

facing out as shown.

7. Reapply the battery cap.

8. Reinstall the VeriLock sensor assembly making

sure the arrow on the face of the sensor is pointing

upward. Continue to fully push the assembly in. The

assembly will snap into place around the lock when

properly inserted.

8. Reinstall lock handle with magnet onto lock lever by

pushing handle onto lock until an audible snap can

be heard.

9. Verify the proper battery polarity by observing the

L.E.D. light illumination during the lock operation.

If the L.E.D. does not illuminate, check to make

sure Steps 6 - 8 were followed correctly and check

to make sure the magnet is positioned properly

around the lock handle as shown.

10. Close and lock the window unit.

11. Verify that the sensor is communicating with your

security system or self-monitoring application

by unlocking the window and checking for the

unlocked message and then open the window and

checking for the window open message.

9142268

400 Series & A-Series

Casement and Awning Windows

(Interior View)

NOTE: VeriLock sensor assembly is

installed on the left lock on awning units,

as viewed from the interior.

Battery

Cap

CR-2025

Battery

Wider edge of VeriLock

sensor assembly toward

side jamb.

Trim Stop

Pry trim stop gently with

putty knife while inserting

VeriLock sensor assembly.

User's Guide

Lock

VeriLock

Lever

Sensor

Assembly

Lock

Handle

Lock

Handle

Magnet

Small Flat Blade

Screwdriver

VeriLock

Sensor

Assembly

Insert screwdriver

into slot end to

remove battery.