Andersen 91939 Installationshandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Installationshandbuch für Türöffnungssystem Andersen 91939 herunter. Andersen 91939 4 Seiten. Replacement for andersen 1-1/2” fullview storm doors

Seite drucken

REMOVE HYDRAULIC

CLOSER AND INSTALL

REPLACEMENT PART

(Left Hand)

With the door seated in the open position look for the hole in the top

of the hydraulic closer unit on top of the door frame. Insert the locking

pin found in the pink hardware bag into the hydraulic closer hole.

From the interior side of the door, loosen the hydraulic closer arm

connecting bolt on the under-side of the rain cap damper assembly

using the hex wrench provided in the pink hardware bag.

NOTE: The connecting bolt is secured to the closer arm.

Once the connecting bolt is completely loose, pull down

slightly on the closer arm and swing the door out of the way.

Hex Wrench

(provided)

LOCKING

HYDRAULIC

CLOSER HOLE

Tools recommended:

Screwdrivers

5/8"

1 1/2"

Close the door until the closer arm is resting against the locking pin

1 1/2"

which will keep the door from closing fully.

1 1/2"

Remove the locking pin from the top of the hydraulic closer unit by

pulling the closer arm slightly away from the door frame and lifting

locking pin from closer hole. Then carefully let the closer arm swing

back to its neutral position over the closer.

Using a Phillips screwdriver, remove the two unpainted screws from

the top of the hydraulic closer unit and properly dispose of the screws.

IMPORTANT

If you have a fixed laminated glass 3-point lock door, go to the

steps on page 4 of this guide after completion of this step (Step D).

CLEAR HARDWARE BAG

Unpainted Flat

Head Screws

(Qty 2)

LOCKING

1/2"