Community R-VTY15 Gebrauchsanweisung - Seite 2

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Redner Community R-VTY15 herunter. Community R-VTY15 4 Seiten. Accessory yokes

TOOLS / MATERIALS NEEDED:

• R.15 or R.35 Loudspeaker

• Accessory Yoke

• Metric Wrench/Socket (13mm, 16mm)

• Mounting hardware appropriate for surface (installer must supply)

INSTALLATION

q Install Vari-Tilt™ wall mount plate or full rotation yoke with hardware rated for the

mounting surface. See Caution below. Fully tighten all hardware.

q For Vari-Tilt™ yokes, follow appropriate illustration (Figure 1 or 2) to secure yoke

between the pinch plate. Snug tighten pinch plate hardware.

q Attach loudspeaker to yoke per instructions in the R.15 / R.35 Loudspeaker

Installation Guide, or per Figure 3. Ensure that the rubber gasket is between the yoke

and enclosure. The hardware to attach the yoke to the loudspeaker is supplied with

the loudspeaker.

q Aim the loudspeaker to the intended audience, set the angle, and tighten all

mounting hardware.

WARNING: Be careful not to over- or under-tighten fasteners. Sufficient torque must be applied to

ensure a secure assembly. Over-tightening can lead to damaged fasteners, thus weakening the

component mounting. Either scenario can lead to risk of assembly separation leading to injury,

death, or property damage.

R-VTY15 Vari-Tilt™ Yoke

Range of rotation from center

CAUTION: Installation of R-Series loudspeakers should only be performed by trained

and qualified personnel. It is strongly recommended that a licensed and certified

professional structural engineer approve the mounting design. Severe injury and/or

loss of life may occur if this product is improperly installed.

78°

63°

8x25 mm Hex Bolt

63°

Figure 1. R-VTY15 installation

Attach wall mount plate to surface -

Installer must supply appropriate hardware

8mm Flat Washer

8 mm Lock Washer

Wall Mount Pinch Plate

Wall Mount Plate

Vari-Tilt Yoke