Bosch Nexxt Premium WTMC6300 Betriebs-, Pflege- und Installationsanleitung - Seite 25
Blättern Sie online oder laden Sie pdf Betriebs-, Pflege- und Installationsanleitung für Trockner Bosch Nexxt Premium WTMC6300 herunter. Bosch Nexxt Premium WTMC6300 28 Seiten.
Cleaning
Cleaning
the dryer
RISK OF EXPLOSION!
Never use solvents or highly
flammable
liquids for cleaning.
Incorrect
cleaning may damage
the dryer. Do not spray with
a water jet. Do not use scouring
agents or all purpose cleaners.
Do not use steam cleaners.
Wipe the housing and fascia with
a soft cloth and soapy water only.
Wipe the drum, door seat and inside
of the door with a damp cloth only.
Cleaning the lint filter
A dirty filter extends the drying time
and increases
energy consumption.
The filter should be cleaned
before
and after each drying process,
however at the latest when the "tint
filter" indicator
light illuminates.
If the "lint filter" indicator
light
illuminates
during a drying program
and a warning signal is emitted,
clean the filter immediately
and
check the exhaust duct.
[_3 The program
interrupts
automatically.
1. Switch off the dryer. Program
selector to "Off".
The inside of the door heats up
during the drying process.
2. Open the door.
3. Remove the lint filter.
4. Remove lint by stroking
your
hand over the filter.
The filter should be rinsed once
a year under warm running water.
The filter must be dried thoroughly
before being replaced.
5. Insert the filter.
6. Close the door.
Cleaning the exhaust
duct
Inspect and clean the exhaust
ducting at least once a year to
prevent clogging.
A partially
clogged
exhaust can lengthen the
drying time.
Turn off the circuit breaker
Pull out power supply plug.
Disconnect
the duct from the
dryer.
Vacuum and reconnect
the
duct.
Cleaning the moisture
sensor
Occasionally
the moisture
sensor
has to be cleaned
because a fine
layer of transparent
buildup is
deposited
on the sensors.
This deposit can easily be removed
by wiping the sensors (the two bars
next to the tint filter) with a cloth
and a little white vinegar.
Use white vinegar only!
Clean the moisture
sensor once
a month.
Cleaning the bearing
shield
Over time, fluff from the drying
process
collects in the bearing
shield.
This fluff can be easily removed
using your vacuum
cleaner, at least
once a month.
25