Community HSB3-BFR22 Anleitung Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Verstärken Community HSB3-BFR22 herunter. Community HSB3-BFR22 12 Seiten. Balancepoint flyware for point source and subwoofer loudspeakers models ip8, ip6, is8, and is6, dual vertical splay with extension kit for 2-way models
Seite druckenROTATIONAL (HINGE) BRACKET
ROTATIONAL (HINGE) BRACKET ANGLE EXPLAINED
The I SERIES full-range loudspeakers are in trapezoidal enclosures. The hinge
bracket is used in many of the array kits to precisely set the angle between two
loudspeakers. The hinges are shipped preassembled with the 6mm fasteners
already in place. They will need to be removed to set your desired splay angle.
IMPORTANT: The splay angles printed on the rotational bracket indicate the
angle between adjacent enclosure surfaces, not (in most cases) the center-to-
center (C-C) loudspeaker aiming angles. For most horizontal and vertical arrays,
the long trapezoidal sides of the enclosures will be adjacent. The total included
trapezoidal cabinet angles are 30° therefore, the C-C loudspeaker aiming angles
will be 30° greater than the enclosure splay angle indicated on the rotational
bracket.
For example, if a C-C loudspeaker array angle of 45° is desired, the 6mm angle
selection fasteners should be placed in the "15°" angle selection holes on the
rotation brackets. 45° (C-C splay angle) – 30° (trapezoidal cabinet angles) = 15°
(splay between adjacent enclosure surfaces).
When using the DVS-BFR22 or DFS kits, the non-angled top and/or bottom
panels are adjacent, therefore, the loudspeaker aiming angle and adjacent
enclosure surface splay angles are identical. For these kits, the angle selected
on the rotational bracket is the same thing as the loudspeaker aiming angle.
15°
between
sides
Basic cabinet geometry and aiming angles
Page 8
30°
15° hole is aligned with
"lighter" hole set
= 15° between cabinets
45°
45° hole is aligned with
the "darker" hole set
= 45° center-to-center splay
BalancePoint™ Flyware
DFS kit shown with IP8-1153 and IP8-1151
0° hole is aligned with
30° splay shown which also equals the
"lighter" hole set
= 0° between cabinets
center-to-center measurement
30° hole is aligned with
the "darker" hole set
= 30° center-to-center splay
= # + 30°
To set angle:
For most applications, and to achieve
center-to-center (C-C) angles greater than
45° you align the "lighter" set of holes with
the marked degree. This number equals the
angle between the loudspeakers, and you
should add 30 to get the C-C measurement.
To achieve 62.5°, 67.5°, or 72.5° (C-C) splay,
the circled outside holes only align with the
holes in the "darker" marked area.
Aligning the "darker" set of holes with the
marked degree hole equals that angle
between centers, and should be used for
downfill (DVS-BFR22, DFS) kits.
30°
30° hole is aligned with
the "darker" hole set
= #
Inner
= # + 30°
I SERIES
Outer