CARNIVORE MM-12 Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Küchengeräte CARNIVORE MM-12 herunter. CARNIVORE MM-12 10 Seiten. Electric meat mincer (240v) 180kg per hour mincing capacity

Seite drucken

Page 9

switch. If this still does not clear the jam disconnect the power lead from the power supply &

disassemble the screw feeder to manually clear the jam. Re-assemble & start to mince again.

5. So both the disk and blade last longer and to maintain their sharpness over time do not tighten the

lock nut excessively.

7. Press the stop button when you have finished using the appliance, remove the power cord from the

power supply then strip the appliance and thoroughly clean both the opening and all other components.

6 REGULAR CLEANING

6.1 GENERALITIES



It is recommended the appliance be thoroughly cleaned & sanitized at least prior to &

definitely after every use.



Thoroughly clean all the various components of the MM-12/MM-22 whether they come in

direct contact with the food product or not.



Never clean the MM-12/MM-22 with a pressurized water-jet, industrial cleaners, wire brushes

or any other type of cleaning utensil that could damage the surface of the appliance.



Before cleaning you must remove the electricity supply plug isolating the appliance from

the main power circuit.

6.2 PROCEDURE TO FOLLOW FOR CLEANING THE APPLIANCE (see fig 6)

- Ensure the appliance is disconnected from the power supply prior to dis-assembly

- Remove the pestle and food tray.

- Unscrew the lock nut and remove the disk, blade, screw feeder, unscrew in the direction indicated by

the arrow.

- Unscrew the knob and remove the mincer block, always in the direction indicated by the arrow.

Now all the components can be washed using warm/hot water and a food safe detergent.

To clean the main body use a damp cloth remember to frequently rinse

The mincing plate mounted on the MM-12/MM-22 should be brushed cleaned. Carefully clean the

punched holes. Make sure all the components are completely dry before remounting them.

N.B. to remount the MM-12/MM-22 follows the above diagrams:

1) Re-insert the mincer block into the main body and lock it in position using the knob; the pin on the

knob must be inserted into the opening.

2) Insert the screw feeder into the mincer block make sure it is positioned correctly.

3) Mount the blade onto the square section on the screw feeder and then mount the disk maintaining

the locating notch to ensure the correct position & ensure it does not spin.

4) Once all the components have been mounted secure by screwing the lock nut in place, ensuring not

to over tighten the locking nut.

www.machineryhouse.com.au

Instructions Manual for MM-12 (F330)

[Type here]

www.machineryhouse.co.nz

10/06/2016