Dreamline Sector Installationsanleitung Handbuch - Seite 4
Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Sanitärprodukt Dreamline Sector herunter. Dreamline Sector 8 Seiten. Shower enclosure
Seite druckenEnclosure Installation
Install a shower tray according to the Tray installation manual. You should do it before the
wonder board and finish wall installation. The shower enclosure has to be installed after
you finish the wall.
1. Assemble Glass profile (02) with Guide rail (03) using Round head screw
ST4.2x25 (11).
2. Push the Stationary glass (04) into Glass profile groove, and then fasten it by Glass
holder (16) with Flat head screws ST4.2×16 (13) to the Guide rail. See Fig 2 for
details.
3. Secure another side of Stationary glass inside of the Glass profile groove with Single
side plastic strip (09). Push Single side plastic strip between glass and side of
groove. See Fig 2 and Fig 3 for details.
4. Push the Wall profile (01) all the way over the Glass profile (02). Be sure to keep a
tong with predrilled holes inside of shower. See Fig 4 for details.
5. Carry the assembled unit on the top of tray; push it against wall. You can adjust
position of the shower by pulling it partially out of the wall profile. Now adjust one of
wall profiles vertically using level and mark holes on the wall. Using help to hold this
profile in the right position, level another profile and mark holes. Gently move the
assembled unit on the side, drill holes into the wall, insert Wall anchors (15). Place
the whole shower assembly on the tray and attach it to the wall using Round head
screws ST4.2×30 screws (10). See Fig 5 and Fig 6 for details.
6. Your unit can be shipped to you with the Wheel assembles (17) installed on the
doors. If not, please refer to diagram (fig 9) how to install it. Attach the top and bottom
wheels to the glass doors. The wheel that goes on the top has an adjustable screw
and nut to adjust the door level. Note that the lock nut of upper wheel should face up.
The bottom wheel has a press button to fix the wheel on the bottom guide rail; that
button should face up. See Fig 7 for details.
7. Secure the Handle (06) to the Glass doors (04). Slide the top door wheels into the
top guide rail and push the bottom wheels in the bottom guide rail by pressing down
the button. Attach the Magnetic strips (07) to the glass doors. Use the Phillips
screwdriver #2 (do not use power screwdriver) to adjust the upper wheels, make
sure they move smoothly and the doors close tight. Then attach the Anti-water strips
(08). See Fig 8 for details.
8. Secure the wall profile and glass profile with Round head screws ST4.2×10 (12).
Cover the screw location with Decorative cover (14). See Fig 9 for details.
9. Seal with silicone caulk between Wall profile, Glass Profile, bottom rail and tray. See
Fig 10 for details.
Rev. 1.4.
4