Bosch DDS183B Betriebs-/Sicherheitshandbuch - Seite 9
Blättern Sie online oder laden Sie pdf Betriebs-/Sicherheitshandbuch für Bohrer Bosch DDS183B herunter. Bosch DDS183B 45 Seiten.
Seite drucken
BM 2610042664 DDS183 HDS183.qxp_HDS 1/4/16 1:11 PM Page 9
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the tool
accidentally.
INSERTING BITS
Move reverse switch lever to the center "OFF"
position. Remove battery pack and rotate the
clutch ring (Model DDS183) or mode selctor
ring (Model HDS183) to the drill bit symbol
"
". To open rotate the chuck sleeve
counter-clockwise viewing from chuck end,
and open chuck to approximate drill bit
diameter. Insert a clean bit up to the drill bit
flutes for small bits, or as far as it will go for
large bits. Close chuck by rotating the chuck
sleeve clockwise and securely tighten by hand
(Fig. 2). Return the clutch ring or mode
selector ring to desired position.
BELT CLIP
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the tool
to fall resulting in injury to the operator or
bystanders.
The belt clip accessory will allow you to
conveniently attach your tool to your belt. This
feature will allow you to have both hands free
when climbing a ladder or moving to another
work area.
The belt clip can be attached to either side of
the tool by securing it with a mounting screw.
Always make sure you securely tighten the
mounting screw before use (Fig. 3).
To use clip, turn tool upside down and attach
to your belt.
DREMEL • 2610042664 01• K/K • 5.50" X 8.50" (AMAC)
Assembly
Disconnect battery pack
from tool before making
When the tool is attached to
the belt, position yourself to
FIG. 3
BELT CLIP
Do not use the power of
the drill while grasping
chuck to loosen or tighten bit. Friction burn
or hand injury is possible if attempting to grasp
the spinning chuck.
CHUCK
FIG. 2
SLEEVE
DRILL BIT
4X BIT TIP HOLDER
Store only bit tips in the
on-tool bit holder. Longer
bits could interfere with proper tool operation
and result in user injury.
The four piece bit tip holder can be used for
convenient on tool storage of your most
commonly used bits.
When mounting bit holder accessory, mount on
the side of the drill opposite the belt clip.
Always make sure you securely tighten the
mounting screw before use. (Fig. 4).
BIT HOLDER
-9-
CLOSE
OPEN
BIT HOLDER
SCREWDRIVER BIT
FIG. 4