Comnet FVR11M Mechanische Installationsanweisungen

Blättern Sie online oder laden Sie pdf Mechanische Installationsanweisungen für Empfänger Comnet FVR11M herunter. Comnet FVR11M 2 Seiten.

Mechanical Installation Instructions

Figure 1: Dimensions are for a ComNet

Power Sources - The product should only be operated from the recommended power source.

Use only a UL Class 2 indoor/dry or Class 3 outdoor/wet power supply.

WARNING: Unit is to be used with a Listed Class 2 or LPS power supply rated 9-12 VDC @ 1A.

WARNING: This unit should be installed in a restricted access location; available through the use

of a lock and key or other means of security. Access should be limited to service personnel who

have been instructed about the reasons for the restrictions to the location. Any and all

precautions should be taken and controlled by the authority responsible for the location.

™

surface mount unit.

FVR11M

Installation Considerations

This fiber-optic link is supplied as

a Standalone module. Units should be

installed in dry locations protected

from extremes of temperature and

humidity.

Standalone Module:

The unit is provided with a mounting

plate with a hole for two No. 6 pan

head screws (3-mm or 3.55-mm).

Attach the module to a solid piece

of wood using two No. 6 pan head

wood screws with a minimum

penetration into the wood of

3/4 inch. (Screws not supplied)

See figure 1.

1. Determine where the module will be

installed, and ensure that there is

adequate space at both ends for

making the various cable

connections and for reading the

diagnostic LEDs.

2. Attach the module to a flat surface

using two mounting screws.

(Not Supplied)

INS_FVR11M_REVA

01/20/09

Page 1