Electrolux EGC3310NVK Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kochfeld Electrolux EGC3310NVK herunter. Electrolux EGC3310NVK 20 Seiten.

Seite drucken

When you assemble each

burner, use the special cap

tool (C) and a screwdriver to

prevent damage to the nuts.

Triple Crown: screw on the nuts with the

diameter of 16 mm (B), included in the

supply (primary air regulators).

Be sure to remove the cap

tool before reassembling the

burners.

3.5 Adjustment of minimum

level

To adjust the minimum level of the

burners:

1. Light the burner.

2. Turn the knob on the minimum

position.

3. Remove the knob.

4. With a thin screwdriver, adjust the

bypass screw position (A).

5. If you change:

• from liquid gas to town gas G110

14mbar, undo the bypass screw

approximately 3/4 of a turn for

Triple Crown burner.

• from town gas G110 14 mbar to

liquid gas, fully tighten the bypass

screw in.

WARNING!

Make sure the flame does

not go out when you quickly

turn the knob from the

maximum position to the

minimum position.

3.6 Replacing the power supply

cable

Use the same type of power supply

cable. This cable must be connected to

the terminal block following the diagram.

230V~

If the power supply is

damaged it must be

substituted by a suitable

cable available in the after

sales service.

Connection to a good earth

wiring system is absolutely

essential. The manufacturer

accepts no responsibility for

any inconvenience caused

by failure to comply with this

rule.

If the power supply cable has to be

replaced, the gauge of the wires in the

new cable must be at least 0.75 mm² (3 x

0.75 cable), the earth wire (yellow-green)

must be at least 20 mm longer at the end

for connection to the appliance.

ENGLISH