ATL ATL-982 Gebrauchsanweisung

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Bedienfeld ATL ATL-982 herunter. ATL ATL-982 6 Seiten. Fire display panel

Instruction Manual of ATL-982 Fire Display Panel

------ Please read this Manual carefully before installing and using the product. -----

I. Product overview

The ATL-982 fire display panel (display panel for short) is a kind of microprocessor-controlled fire display

panel developed by our company. Each display panel is connected to a fire alarm control panel produced

by our company via a special RS-485 interface to process and display the data sent from the fire alarm

control panel. Each floor of a building may have a display panel installed. When there is a fire alarm on

the floor where the display panel is installed, or the neighboring floor above or below it, the display panel

will give a horn/strobe alarm and display the floor No., the room No., and some other position information

of the fire alarm.

II. Product features



Each display panel is connected with a fire alarm control panel via a RS-48 bus. At most 99

display panels may be connected with each RS-485 bus.



The display panels can display fire alarm messages or feedback messages only rather than fault

messages, action messages or other messages.



A fire alarm control panel may be used for setting the display area of a display panel. The set

display panel can display the fire alarm messages of the designated area (floor display) only.

Note: See the User's Manual of the fire alarm control panel for the setting method.



It can replace a JB-FSD-981 fire display panel in a 2100 system.

III. Technical parameters

Executive standard: General Technical Conditions for Fire Indicating Panels (GB17429-1998)

Display capacity: Each display panel can display the fire alarm messages of floors -10~90

and at most 99 fire alarm messages or feedback messages.

Wiring system: Four-wire system, power lines (+24V, GND) and RS485 signal lines (485A,

485B)

Operating environment: Indoor; temperature: -10℃～+50℃; relative humidity: ≤95% (40℃,

without condensation)

Power supply: DC 24V ±20 %

Overall power consumption: ＜3W

Contact capacity: Relay dry contacts, normally open or normally closed, capacity:

1.25A/DC30V (resistive load)

IV. Appearance and dimensions (see Fig.1)

Fig.1

第 1 页共 6 页

Version number: 5025100811