Electrolux EGU6343 Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kochfeld Electrolux EGU6343 herunter. Electrolux EGU6343 16 Seiten. 60cm wide xline gas on glass hob with 4 burners and individual cast iron pan supports.

Seite drucken

It is important to install the elbow

correctly, with the shoulder on the

end of the thread, fitted to the hob

connecting pipe.

Failure to ensure the correct as-

sembly will cause leakage of gas.

Make sure that the gas supply

pressure of the appliance obeys

the recommended values.

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end).

7.3 Injectors replacement

Remove the pan supports.

Remove the caps and crowns of the

burner.

With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in "Technical

Information" chapter).

Assemble the parts, follow the same

procedure backwards.

Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied with

the appliance.

If the supply gas pressure is changeable or

different from the necessary pressure, you

must fit an applicable pressure adjuster on

the gas supply pipe.

7.4 Adjustment of minimum level

To adjust the minimum level of the burners:

Light the burner.

Turn the knob on the minimum posi-

tion.

Remove the knob.

With a thin screwdriver, adjust the by-

pass screw position.

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the by-

pass screw in.

• If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn (1/2 of

a turn for Triple Crown burner).

WARNING!

Make sure the flame does not go

out when you quickly turn the knob

from the maximum position to the

minimum position.

7.5 Electrical connection

• The electrical work necessary to install

the appliance must be done by a quali-

fied electrician or competent person, ac-

cording to the current regulations.

• The appliance must be earthed.

• Always use a correctly installed shock-

proof socket.

• Make sure that there is access to the

mains plug after the installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• The appliance must not be connected

with an extension cable, an adapter or a

multiple socket. There is a risk of fire.

Make sure that the ground connection

complies with the standards and regula-

tions force.

• The power cable must not touch any hot

parts.

• The electrical installation must have an

isolation device which lets you discon-

nect the appliance from the mains at all

poles. The isolation device must have a

contact opening width of minimum 3

mm.

• You must have the correct isolation devi-

ces: line protecting cut-outs, fuses

ENGLISH