Alera ALE-SB625234 Schnelle Montage - Seite 2

Blättern Sie online oder laden Sie pdf Schnelle Montage für Inneneinrichtung Alera ALE-SB625234 herunter. Alera ALE-SB625234 4 Seiten. Bookcase

Seite drucken
Assembly Instructions
TIPS FOR EASIER ASSEMBLY:
• 2-person assembly is recommended.
• Assemble the unit on a flat surface.
• Some locking tabs may flatten out or bend open during transport.
Adjustments can easily be made using a small blade screwdriver with light pressure.
Step 1
Back Assembly
-
A)
Lay the two back panels on a flat
surface. Position as illustrated.
B)
Place the Right Back Panel (D) over the
Left Back Panel (C) inserting the tabs into the
matching holes.
C)
Once all the tabs are started, slide the Back Panels
in opposite directions to fully engage the tabs.
D)
Tap the tabs down with a rubber mallet to
tighten the connections.
NOTE: On the 72" and 84" models, use care when handling
the Back Panels. They bend very easily if not handled properly.
Use 2 hands and NEVER put your fingers in the slots.
When lifting, position both hands near the center
of the Back Panel as shown to avoid bending it
Step 2
Side Assembly
-
A)
While the Back Panels are still lying on a
flat surface, lift the outside edge of the
Right Back Panel (D) and slide the L-shaped
bend of the Right Side Panel (B) under it.
B)
Insert the tabs on the Right Back Panel (B)
into the matching square holes in the
Right Back Panel (D).
C)
Once all the tabs are started, slide the Side
and Back Panels in opposite directions to fully
engage the tabs.
D)
Tap each of the tabs down with a rubber mallet to
tighten the connections.
E)
Repeat the steps with the Left Side Panel (A).
Quick Assembly Bookcase
Insert the tabs into the matching holes
Right Side Panel - B
Right Back Panel - D
Square
Holes
Tabs
Right Back Panel
Left Back Panel
Lift the edge of Back Panels
and set them over the Sides,
inserting the tabs through the
matching square holes.
Square
Holes
Right Back Panel - D
Left Back Panel - C
Locking Tab
Can be adjusted open or closed to ease assembly
Bend is up
Left Back Panel - C
Slide the panels to fully engage the tabs and tap them down
IMPORTANT:
Make sure the bends on the Side
Panels are on the same side
as the Back Panels
Square Holes
on Back Panels
Left Side Panel - A
Tabs
on Side Panels
Slide the panels to fully engage the tabs and tap them down
Page 2
Bend is up
(shown transparent)