Dremel DigiLab 3D45 Handbuch
Blättern Sie online oder laden Sie pdf Handbuch für 3D-Drucker Dremel DigiLab 3D45 herunter. Dremel DigiLab 3D45 4 Seiten. Print removal
Auch für Dremel DigiLab 3D45: Schnellstart-Handbuch (2 seiten), Dienstanweisungen (4 seiten), Gebrauchsanweisung (2 seiten), Service-Handbuch (4 seiten), Handbuch Kalibrierung (2 seiten), Schnellstart-Handbuch (2 seiten)
Seite drucken
Read the Dremel 3D45 manual and
these instructions before unclogged
the extruder in your Dremel 3D45. Failure to comply with
the warnings and instructions may result in fire, equip-
ment damage, property damage, or personal injury.
Always unplug Dremel 3D45 from its power before per-
forming any service procedures. Failure to do so may re-
sult in personal injury and equipment damage.
Use only Dremel approved materials and components.
Use of object materials, or 3D objects other than Dremel
approved object materials and genuine Dremel components
may void warranty.
Repairs on the Dremel 3D45 may require the use of special
tools (pulling devices and bearing press). Authorized repair
centers have trained repair technicians and equipment
necessary to perform these repairs.
This document will outline the steps necessary to clear a
clog in the heatsink tube assembly caused by the filament
bulging up inside the tube. If the filament becomes clogged,
neither loading nor unloading will be possible. Tube clogging
can occur by either using an old filament that's kept in the
open for a longer duration or from 3rd party filaments with
lower transition temperatures.
Tools Required:
• Unclog tool
• Brush
• Scissors
• Pliers
• 2mm Hex bit or Hex wrench (Allen key)
• 2.5mm Hex bit or Hex wrench (Allen key)
• T10 Torx bit or screwdriver (no longer than 4 inches).
3D45 Unclog Extruder
PRE-SERVICE PREPARATION
For the location of the repair center near you, please call
1-844-4DRML3D (1-844-437-6533) Monday thru Friday,
8AM to 6PM CST. Or, look on our web site at
www.Dremel3D.com and follow the link for 'Support'.
CONTINENTAL UNITED STATES
Dremel Service Center
4915 21st Street
Racine, WI 53406
Phone: 1-844-4DRML3D
Preventative Measures:
In order to help avoid clogging please follow the recommen-
dations below.
1. Only use Dremel filament.
2. Always unload the filament from the printer when not in
use.
3. Always wait for the extruder to cool down see thermome-
ter icon on screen empty.
4. Store your filament in a dry environment with a desiccant
bag and clip the free end of the filament to the two holes
in the spool to prevent filament getting tangled or brittle-
ness.
Please call Dremel service center for help in unclogging
your extruder.
CANADA
Giles Tool Agency
47 Granger Ave,
Scarborough, ON
M1K 3K9, Canada
Phone:1-416-287-3000
West Coast Tool
4008 Myrtle Street
Burnaby, B.C. V5C 4G2
Phone: 1-604-873-5394