Dremel GO DRAFT Betriebs-/Sicherheitshandbuch - Seite 10

Blättern Sie online oder laden Sie pdf Betriebs-/Sicherheitshandbuch für Werkzeuge Dremel GO DRAFT herunter. Dremel GO DRAFT 13 Seiten.

Seite drucken

INSERTING BITS

Your tool is equipped with a bit holder 1.

Simply push a bit 10 into the bit holder 1 as far

as it will go (Fig. 1).

DIRECTION OF ROTATION

direction of rotation switch while the power

tool is in operation.

Clockwise rotation: To drive screws in, slide

the direction of rotation switch 2 down or

forward to position A (Fig. 2).

Counterclockwise rotation: To loosen or

unscrew screws, slide the direction of rotation

switch 2 up or backwards to position B (Fig. 2).

Locking the shaft in place: To lock the shaft

(bit holder 1) in place, slide the direction of

rotation switch 2 into the middle position C

(Fig. 3). This enables screws to be screwed in

manually, e.g. when the battery is depleted.

slide the direction of rotation switch to

middle (locked) position when storing or

transporting the tool.

SETTING THE TORQUE

The required torque can be set in one of six

positions using the torque selector 4. The tool

will stop as soon as the set torque is reached.

Position 1: Lower torque for screwing in

screws with small diameter or into soft

materials.

Operating Instructions

To prevent damage to the

tool, do not use the

Fig. 2

To prevent accidental

activation of the tool,

Position 6: Higher torque for screwing in

screws with large diameter or into hard

materials.

STARTING AND STOPPING THE TOOL

To start the power tool, put pressure on the bit

holder 1 and maintain this pressure to continue

using the power tool. To switch the tool off,

stop putting pressure on the bit holder 1.

FASTENING WITH SCREWS

The procedure shown in figure 4 will enable

you to fasten materials together with your

Cordless Screwdriver without stripping,

splitting, or separating the material.

First, clamp the pieces together and drill the

first hole 2/3 the diameter of the screw. If the

material is soft, drill only 2/3 the proper length.

If it is hard, drill the entire length.

Second, unclamp the pieces and drill the

second hole the same diameter as the screw

shank in the first or top piece of wood.

FASTENING

WITH SCREWS

1. Drill 2/3 diameter and

2/3 of screw length for

soft materials, full

length for hard

materials.

Apply a slight

even pressure

when driving

screws.

-10-

Fig. 3

Fig. 4

2. Drill same

diameter as

screw shank.

3. Countersink

Screw

same

diameter

as screw

head.