Andover Controls ACC EMX 156 Installationshandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Installationshandbuch für IP-Zugangssteuerungen Andover Controls ACC EMX 156 herunter. Andover Controls ACC EMX 156 4 Seiten.

Seite drucken

3.If you are connecting more than one EMX 156 module

to your Infinet controller, connect the second one to the

bottom of the first.

4.Set the BOARD switch (upper right) to 1 on the first EMX

156, and the BOARD switch to 2 on the second EMX 156.

If you do not plan to connect more than one EMX 156

module, set the BOARD switch to 1.

Never set two modules of the same model number to the

same board number.

3. Connect the External Power Supply

(if necessary)

If you are installing multiple modules, you may need an

external power supply. To determine what you need, refer

to the ACC EMX Modules Configuration Guide.

Figure 2 shows where you connect the external power supply

to the 2-pin Berg type connector on the EMX 156.

Figure 2. Location of External Power Connection

and External Power Supply Jumper

BOARD

OVERRIDE

Override

Switches

AUTO OFF ON AUTO OFF ON

EMX156

INPUTS

VOLTS 24V

AMPS 36MA

OUTPUTS

VOLTS 240V

AMPS 3.5A

DATE

4. Reposition Jumper of One Module

The Berg type connector immediately to the left of the ex-

ternal power supply connection has a jumper that you

reposition to indicate you are using external power.

Figure 3 shows the jumper in the two possible positions, one

for the internal power supply, the other for the external. Move

the jumper to the external power supply position.

www.PDF-Zoo.com

Click for EMX Menu

OUTPUT

LOAD

OUTPUT

24VDC

CLASS

I I

U L

LISTED

58B2

ACCESSORY EQUIPMENT

FOR USE WITH

SCX LCX AND TCX UNITS

EMX 156 Installation Guide 2

You change the jumper position only on the module or mod-

ules connected to the external power supply, not on any other

modules.

Note

You need to change the jumper position only on the mod-

ule(s) actually connected to an external power supply. Never

change the jumper position of other modules.

Figure 3. Jumper Positions for Internal and External

Power Supplies

Jumper Position,

Internal Power

Supply

Each is set to the internal position when you receive it.

Wire the Outputs

You wire the outputs as follows:

1.Slip the appropriate wires under the Load A screws and

tighten the screw down on it.

2.Slip the appropriate wires under the Load B screws and

tighten the screws down on it.

Figure 4 illustrates the wiring for Form A outputs.

Figure 4. Wiring Diagram for Form A Outputs

Connect

Load A

External

Power

Supply

Here

Move

External

Troubleshoot

Power

Jumper

If you have problems with the Infinet controller after in-

stalling the module, see your Andover Controls

representative for details.

Refer to the EnergyNet and Infinet Configuration Guide

for information on how to troubleshoot network and pow-

er supply problems.

Jumper Position,

External Power

Supply